Loading ...
Loading ...
Loading ...
RESETTING THE INTERNAL SOFTWARE
SYSTEM
If the error codes EC or E4 appear, please do the
following:
a)
Remove all cookware from the cooktop. Have an inductive pot or pan with a bottom
diameter of at least 16cm close by for use during the procedure.
b)
Remove the Cooktop from the power supply for a few minutes, by turning the circuit
breaker off or removing the fuse.
c)
Reconnect the Cooktop to the power supply. There is now 2 minutes to start the next step,
otherwise repeat the above.
d)
STEP 1: Without pressing the On/off power touch control, press Boost Power touch control
and keep touching with one finger. A “-“ symbol will appear in the four Cooking Zone Select
touch control & Power LED displays. While still touching the Boost Power touch control,
quickly press each
Timer/Zone Power touch control (less than 2 seconds) in succession, starting from RHF, to
RHR, LHR and ending at LHF. If a double beep is heard, a mistake has been made & the
process needs to start from the beginning. If not, remove all fingers from the control panel
and press Simmer Power touch control (03) for a few seconds until flashing “E” symbols
appear. Wait until the symbols stop flashing and change to “C” on each LED display. This
means the old software has been purged from the Cooktop.
e)
STEP 2: Select a cooking zone by pressing the Cooking Zone Select touch control & Power
LED display. Place the pot or pan centrally in the cooking zone. Wait for the LED display to
change from
“C” to a “-“. Repeat for every cooking zone. Do not use multiple pots or pans, or change
during the process. Once all the Cooking Zone Select touch control & Power LED displays
are showing “-“, the process is finished.
f)
The Cooktop should now turn off and on again correctly. If the error codes persist, please
contact the Omega Service Department.
14
Loading ...
Loading ...
Loading ...