Loading ...
Loading ...
Loading ...
Keep Warm Function
The Keep Warm Function can be used to keep food warm for long periods of time (up to 2
hours). The cookware can be removed from the element for up to 10 minutes without
disabling the function.
1.
The Cooktop must be set to Operating-Mode.
2.
Select one of the cooking zones. Press the Keep Warm Function Touch Control (03) and
the Cooking Zone Select touch control & Power LED display of the selected cooking zone
will change to “U”.
3.
The function can be disabled by adjusting the cooking zone power level.
Stop N Go Function
The Stop N Go Function allows you to stop all activity on the Cooktop (cooking, timers) and
restart for where you left off at a later time.
1.
While the Cooktop is in Operating-Mode, press the Stop N Go/Recall Function Touch
Control (02). A pause symbol “ll” will appear in each Cooking Zone Select touch control &
Power LED display and the indicator above the sensor will light up. All functions will pause,
and all touch sensors disabled (except for On/Off Power touch control).
2.
Once ready to restart, press the Stop N Go/Recall Function Touch Control (02) again. The
indicator above the sensor will flash for 2 seconds. Press any other touch sensor within that
2 seconds and the pause symbols will disappear. The Cooktop will then continue to work
as it was before.
Recall Function
There may be times when you are cooking and press the On/Off Power touch control by
mistake, deleting all functions and timers. If the On/Off Power touch control is pressed again
(within 6 seconds of the Cooktop being set to Stand-By-Mode), the indicator above the Stop N
Go/Recall Function Touch Control (02) will flash for 5 seconds. Press the Stop N Go/Recall
Function Touch Control while it’s flashing, and the previous settings for the Cooktop will be
recalled.
TOUCH CONTROL SAFETY FUNCTIONS
The following safety functions are available to avoid unintended operations of the cooktop
control:
Pan Detection Failure
If a cooking zone is activated and undersized cookware, incorrect material cookware or no
cookware is detected, the symbol U will be displayed on the cooking zone LED display and the
cooking zone will be disabled. Place or replace cookware on the cooking zone.
Residual Heat Functions
After all cooking processes there is some heat stored in the glass top called residual heat. The
control can calculate roughly how hot the glass is in the worst case. If the calculated
temperature is higher than + 60 ° C, then this will be indicated in the corresponding Cooking
Zone Select touch control & Power LED display with a red “H” after the cooktop has turned off.
The residual heat display is shown as long as the calculated cooking zone temperature is > +
60 ° C.
9
Loading ...
Loading ...
Loading ...