Loading ...
Loading ...
Loading ...
Anti-tip
bracket
Anti-tip foot
English 27
Installation Instructions
Gas Connection, cont.
Before sliding the range into the cabinet
1. Turn off the gas-supply valve, and turn off
power to the range.
2. Connect a flexible gas line to the shut-off valve
installed on the stub out. The line must be long
enough that the range can be pulled out for
service without disconnecting the line.
3. Slide the gas line up through the chassis' access
holes to the regulator. (Move the wires inside
the access holes to keep them from catching on
the gas line.)
4. Connect the gas line to the regulator.
5. Turn off all cooktop controls, then turn on the
gas supply.
6. With a soap-and-water solution, check all lines
and connections for leaks.
7. Turn off the gas-supply valve.
Regulator connection
Gas line
Final Installation
Back of range
Rear leg
1 1/4” *
* Distance to floor:
4 1/16” to 5 5/16”
Anti-Tip Foot
(location varies)
up
down
1.
2.
3.
Peel the protective sheeting from the range.
Measure from floor to countertop. Adjust the
leveling legs as needed to position the trim
around the cooktop even with or above the
countertop.
Turn to lower the anti-tip foot at the back of
the range until it is 1/16” (2 mm) off the floor.
4. Slide the range into the cutout so the anti-tip
foot engages the anti-tip bracket. (Use a
flashlight to verify.)
5. With a level, check that the range does not tilt
in any direction. (Adjust the legs to level the
range as needed.)
Loading ...
Loading ...
Loading ...