Loading ...
Loading ...
Loading ...
4
www.napoleonreplaces.com
GENERAL INFORMATION
This appliance should be installed and serviced by a qualied installer to conform with local codes.
Installaon pracces vary from region to region and it is important to know the specics that apply to your
area, for example: in Massachuses State:
• The appliance o valve must be a “T” handle gas cock.
• The exible connector must not be longer than 36 inches.
The installaon must conform with local codes or in the absence of local codes, with the Naonal Fuel Gas
Code ANSI Z223.1/INFPA 54 in the United States or CSA B149.1, Natural and Propane Installaon code in
Canada.
The appliance and its individual shut o valve must be disconnected from the gas supply piping system during
any pressure tesng of the system at test pressures in excess of 1/2 psig (3.5kPa).
This appliance must be isolated from the gas supply piping system by closing its individual manual shut o valve
during any pressure tesng of the gas supply piping system at test pressures equal to or less than 1/2 psig (3.5kPa).
The following clearances to combusble materials must be maintained:
Sides (all around) - 24 inches (610mm)
Top - 72 inches (1.830m)
• Always keep the appliance area clear and free from combusble materials, gasoline, and other ammable
vapours and liquids.
• Do not locate appliance where it can get excessively
wet.
• Do not use this appliance if any part has been
under water. Immediately call a qualied service
technician to inspect the unit and to replace any
part of the control system and any gas control
which has been underwater.
Loading ...
Loading ...
Loading ...