Loading ...
Loading ...
Loading ...
38
Operation
Using the Control Panel
SYNCHRONIZE THE CONTROL PANEL
To synchronize the control panel to the garage door opener, press the push bar until the garage door opener
activates (it may take up to 3 presses). Test the control panel by pressing the push bar, each press of the
push bar will activate the garage door opener.
NOTE: Your control panel may look different than the illustrations.
Up to 2 Smart Control Panels® or 4 of any other Security+ 2.0 control panels can be connected to the garage
door opener.
Push Bar
LIGHT
button
Screen
Motion
Sensor
Navigation
Buttons
PUSH BAR
Press the push bar to open or close the door.
NAVIGATION BUTTONS
Use the navigation buttons to make selections and program features.
LIGHT BUTTON
Press the LIGHT button to turn the garage door opener lights on or off. When the lights are turned on they will
stay on until the LIGHT button is pressed again, or until the garage door opener is activated. Once the garage
door opener is activated the lights will turn off after the specified period of time (the factory setting is 4-1/2
minutes). The LIGHT button will not control the lights when the door is in motion.
SCREEN*
The screen will display the time and temperature until the menu button is pressed, and then it will display the
menu options. If there is a problem with the garage door opener the screen will display the Diagnostic Code.
Refer to the Troubleshooting section.
The following features are accessible through the screen using the navigation buttons:
LEARN A DEVICE
Program compatible remote controls, wireless keyless entries, Wi-Fi garage door openers, or myQ® accessories
to the garage door opener.
LOCK
The LOCK feature is designed to prevent activation of the garage door opener from remote controls while still
allowing activation from the control panel and keyless entry. This feature is useful for added peace of mind
when the home is empty (i.e. vacation).
TIMER-TO-CLOSE (TTC)*
DO NOT enable TTC if operating a one-piece door. TTC is to be used ONLY with sectional doors. Factory default
is set to off. TTC can be set to automatically close your garage door from the fully open position after a specified
period of time (1, 5, 10 minute intervals or a custom setting up to 99 minutes). The garage door opener will
Beep and the lights will Flash before closing the door. The screen on the control panel can display the status of
the TTC. TTC WILL NOT work if the garage door opener is operating by battery power or if the safety reversing
sensors are misaligned. This feature is NOT intended to be the primary method of closing the door.
A keyless
entry should be installed in the event of an accidental lock out when using this feature.
AUTOMATIC LIGHT
Motion Sensor *
Factory default is set to on. This feature automatically turns on the garage door opener lights when motion is
sensed. The lights will come on for the set period of time, then shut off. If using the garage door opener light as
a work light disable the motion sensor, otherwise the light will turn off automatically if you are beyond the range
of the sensor.
MAINTENANCE ALERT (MAS)
This feature assists the homeowner in ensuring the garage door opener system stays in good working condition.
When the garage door opener needs to be serviced (approximately 4500 garage door opener cycles) the
command (yellow) and service (red) LEDs will begin to alternately flash back and forth. The factory setting for
the MAS feature is off and can be activated at time of installation. Contact your installing dealer for service.
*If applicable
Loading ...
Loading ...
Loading ...