Loading ...
Loading ...
Loading ...
page 8
9. Blade Assembly.
WARNING: To reduce the risk of serious bodily injury, DO
NOT use power tools to assemble the blades. If screws are
overtightened, blades may crack and break.
Time Saver: Washers for blade screws can be set on each
blade screw prior to installing blades.
Locate 9 blade attachment screws and washers and
9 decorative nuts in one of the hardware packs. Place
blade arm on TOPSIDE of blade, aligning holes in blade
arm with holes in blade as shown. Insert 3 decoratvie nuts
into holes in blade from UNDERSIDE of blade (i.e., the side
that will face the floor), making sure to completely insert
each decorative nut so that the blade arm can be attached
correctly. Insert 3 blade attachment screws (along with
washers) from TOPSIDE of blade with fingers first and then
tighten screws securely with a Phillips screwdriver. Repeat
procedure for remaining blades.
Remove blade arm screws and lock washers from fan
motor and set aside. [WARNING: Do NOT remove the 4
screws located on the outer rim of the underside of the
motor housing--doing so or any attempt at doing so will
void the warranty.] Align blade arm holes with motor
screw holes and attach blade arm with lock washers and
blade arm screws. Before securing screws permanently,
repeat this procedure with remaining blade arms. Secure
all screws.
NOTE: Tighten blade arm screws twice a year.
10. Light Kit Assembly.
motor
housing
blade
decorative
nuts
blade arm
blade attachment
screws and washers
blade arm screws
and lock washers
motor housing
light kit fitter
motor plate
male plug
female plug
TRANSMITTER
(front)
LED light kit
molex
connections
glass shade
motor housing
post
light kit fitter
Remove 1 screw from motor plate on underside
of motor housing and partially loosen the other
2 screws. Connect male plug from motor
housing to female plug from the light kit fitter.
Make sure plugs connect tightly. Align slotted
holes in light kit fitter with loosened screws in
motor plate. Twist light kit fitter to lock. Re-insert
screw that was previously removed and securely
tighten all 3 screws with a Phillips screwdriver.
Remove 1 screw from post located on underside
of light kit fitter and partially loosen the other 3
screws.
Connect WHITE wire from LED light kit to
WHITE wire from light kit fitter. Connect BLACK
wire from LED light kit to BLACK (or BLUE) wire
from light kit fitter. Be sure that molex
connections snap together completely.
Align slotted holes in LED light kit with loosened
screws in light kit fitter. Twist LED light kit to
lock. Re-insert screw that was previously
removed and tighten all 4 screws securely.
Align grooves on glass shade with nodules on
inside of LED light kit and push up gently on
glass shade. Twist glass shade to the RIGHT
(clockwise) until glass shade locks into place.
Pull down VERY GENTLY on glass shade to make
sure that glass shade is secure.
Loading ...
Loading ...
Loading ...