Loading ...
Loading ...
ASSEMBLY INSTRUCTIONS
3
Outlet Box
STEP 1:
a. Secure the crossbar (AA) to the outlet box (not
included) with outlet box screws (CC). Tighten
until snug.
The preassembled mounting screws on the
crossbar should protrude outward.
Note:
CC
AA
STEP 2:
a. Remove mounting balls from the crossbar
assembly (AA).
b. Fit the ceiling canopy to the crossbar assembly
and secure with mounting balls.
The ceiling canopy should be snug against
the ceiling and the mounting balls.
If not, adjust the length of the mounting screws on
the crossbar assembly by unscrewing the
preassembled hex nuts.
Then, screw the mounting screws in or out of the
crossbar until the desired length is achieved.
Once the ceiling canopy is secure, remove the
mounting balls and ceiling canopy and proceed to
Step 3.
Note:
?
?
?
Mounting
Screw
Hex Nut
Mounting Ball
Ceiling Canopy
WHITE
BLACK (OR RED) WIRE
WHITE OR RIBBED
BLACK OR SMOOTH
FROM SUPPLY
FROM SUPPLY
FROM FIXTURE
FROM FIXTURE
STEP 3:
* Use Wire Connectors (supplied) to connect the
wires.
ground wire green ground
screw
ground screw
ground wire supply
ground
supply white wire white
fixture supply wire
supply black (or red)
black fixture supply wire
a) Ground Wire:
1. Wrap supply around
on mounting bracket, no less than 2 in.
from the end of the wire. Tighten .
2. Connect fixture green to
wire with wire connector.
b) Supply Wire:
1. Connect the to the
with wire connector.
2. Connect the wire to the
with wire connector.
3. Wrap each connection with approved electrical
tape and carefully stuff all of the connected wires
into the outlet box.
GROUND WIRE
GROUND WIRE
FROM SUPPLY
FROM FIXTURE
GREEN GROUND SCREW
STEP 3:
a. The lanyard is provided as a means to support the
fixture from the junction box while connecting the
electrical wires. This enables the fixture to hang
from the junction box and your hands are free to
make the wire connections.
b. Turn the button stop so it may be inserted into the
crossbar slot. Make sure the button stop is
completely inside the crossbar.
c. Slowly release the fixture to make sure it is
supported by the button stop.
d. Proceed to Step 4. Once wiring is complete, the
lanyard will push into the junction box when the
Ceiling Canopy is Attached to the ceiling.
Ceiling Canopy
Slot
AA
Button Stop
Lanyard
Loading ...