Loading ...
Loading ...
Loading ...
Problem Possible Cause Solution
Machine Power cord not plugged in. Plug inpower cord.
Stops No power at plug. Check electricaI source or caII
eIectrician.
Fuse blown or circuit Replace fuse or reset circuit breaker.
breaker open. IfprobIem continues, call eIectrician.
Using an extension cord. Do not use extension cords.
Timer is not lined up. Turntimer to the right sIightly
and pulI to start.
Timer knob not pulled out. Set and pull out knob.
Washer at pause in Allow cycleto continue (see
PERMANENT PRESS IICycle "Operatiing Your Washer").
(approximately two minutes).
Machine is ovedoaded. Wash smaller loads.
Agitator Not The top of the agitator moves This is normal
Working only in one direction.
The top of the agitator is loose. This is normal
Water Level The top of the agitator is much This is normal
Too Low/Not higher than the highestwater
Completely level. This createsa perception
Filling of the washer not being fuIl.
Tub is Tub pulled forward when Ensure tub is centered before
Crooked unloading, starting washer.
Tub moves. This is normal
Unit not level. Ensure front feet are instalIed and
nuts aretightened. Levelwasher.
Reset rear legs (see "Installation
Instructions,"Section G).
Lint on Load Improper sorting. Sort Iint givers from lint takers
and by color.
Overloading. Lint can be trapped in load if
overloaded. Wash smaller loads.
Paper or tissue in pockets. Clean out pockets before washing.
Not enough detergent. Use enough detergent to
hold lint in water.
Detergent not dissolving. UseAutomatic Temperature ControI
Water temperatures lower (ATC).ATC ensures wash water
than 70°F (21°C). temperature wiII bewarmer than
70°F (21°C).
37
Loading ...
Loading ...
Loading ...