Loading ...
Loading ...
Loading ...
20
REFRIGERATED BASES & PIZZA PREP TABLES
OPERATIONS MANUAL
Check that both plates are secure and that the casters turn
and swivel freely. Carefully lift the cabinet upright and double
check that the caster support plates are secure and the cabinet
is stable. Wait at least 3 hours before turning the refrigeration
system back on, and at least another 30 minutes for the cabinet
to come down to temperature and stabilize, before reloading
with product.
INSTALLING ELECTRIC CONDENSATE HEATER
The condensate heater has a thermal limit switch and power
cord attached. Remove the screws for the rear access panel
from the cabinet and set aside. Place the condensate heater in
the drain pan as shown in Figure 17. Position the end of the
plastic drain tube in the pan. Make sure tubing isn’t kinked, is
secure and doesn’t touch the heater. Plug the heater power cord
into the receptacle labeled “vaporizer”. Secure excess cord with
a wire tie, so it doesn’t fall into the pan or under the cabinet.
Reattach the access panel to the back of the cabinet.
IMPORTANT NOTE: It is extremely important to ensure
the condensate heater is plugged into the receptacle
labeled “vaporizer” and that the condensing unit is
plugged into the receptacle labeled “condensing unit.”
DIAL THERMOMETER AND CALIBRATION
Your NSF-approved dial thermometer has a remote sensing
bulb, located in the refrigerated compartment. The display fea-
tures a large 2” diameter face, with an easy-to-read scale that
shows the internal cabinet temperature in Fahrenheit (°F) and
To install caster support plate assemblies, you will need a 3/4”
open end wrench (or a large adjustable wrench), a drill with a
1/8” bit and a Phillips bit (or a Phillips-Head screwdriver) plus
work gloves. A 1/2-13 thread tap is also recommended, to repair
any damage to the threaded inserts in the cabinet. Unload all
product and carefully lay the cabinet on its back. Remove the old
stem casters by unscrewing them from the cabinet. If a caster or
threaded insert has been stripped or cross-threaded, it may be
necessary to use a wrench to loosen the caster.
Hold one of the support plate assemblies under the cabinet as
shown (see Figure 16). Position it so the slotted holes at the end
of the plate line up with the threaded inserts in the bottom of the
cabinet (where the stem casters were attached). Attach the plate
assembly to the cabinet by putting a 1/2” x 1-3/4” long bolts and
flat washer through the slot in the support plate and screwing
into each of the threaded inserts in the bottom of the cabinet.
Snug the bolts down, but do not tighten them completely. If
one of the threaded inserts is stripped or damaged, a thread tap
should be used to clean the threads.
Using the small holes in the plate as a template, drill 1/8 pilot
holes in the bottom of the cabinet. (Note: drill only until you
penetrate the metal bottom of the cabinet. Do not continue
to drill into the insulation, or you may damage the cabinet.)
Secure the caster support plate assembly to the cabinet with a
sheet metal screw in each of the drilled holes. Tighten the 1/2”
bolts. Repeat these steps to attach the other plate assembly to
the opposite end of the cabinet.
FIGURE 16: Caster Support Plates
FIGURE 17: Electric Condensate Heater
Loading ...
Loading ...
Loading ...