Loading ...
Loading ...
Loading ...
Controls & Features
4
9Section 4 — controlS & FeatureS
NOTE: Photographs and line drawings used in this manual are for reference only and do not represent a specific model.
Compare the illustrations with your unit to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference.
Spray Wand
Allows the user to quickly change out high pressure
nozzles. Refer to “How To Use Spray Wand”
instructions in Operation section.
Detergent Siphon Hose (Not Shown)
Feeds cleaning agents into the pump to mix with
the water. See “How to Apply Chemicals/Cleaning
Solvents” instructions.
Water Tank
Large water reservoir tank for storage and
transportation of water. Features an outlet to the
pump inlet for dispensing water.
Tank Fill Hose
Some models feature a hose and reel allowing to
connect the water reservoir tank to a water source
from a distance without introducing a stand-alone
garden hose.
Hose Retainer
Some models feature a short length of hose allowing
to connect the reservoir tank to a water source with
the use of a stand-alone garden hose.
Swing-Back Jack Stand
Used to support the unit when not being towed.
Trailer Hitch
Connects to ball mount on road vehicle for towing.
Trailer Light Harness
Connect the taillight harness to the outlet on the rear
of the towing vehicle. Always make sure that the red
taillights function properly before towing.
Pressure Washer Terminology
PSI
Pounds per Square Inch. The unit of measure for
water pressure.
GPM
Gallons per Minute. The unit of measure for the flow
rate of water.
CU
Cleaning Units. GPM multiplied by PSI equals CU.
Bypass Mode
Allows water to re-circulate within the pump when
the gun trigger is not pulled. This feature allows the
operator to release the trigger gun and reposition
themselves without having to turn the engine off in
between cleaning actions.
NOTICE: Allowing the unit to run for more than
two minutes without the gun trigger being pulled
could cause overheating and damage to the pump.
Do not let the pressure washer run for more than
two minutes in Bypass Mode. Turn off the engine
and relieve the pressure in the gun during these
extended situations.
High Pressure Pump
Located at the back of the engine. Increases the
pressure of the water supply as it is forced through
the high pressure hose and spray gun. Refer to
Maintenance section for more information.
High Pressure Hose & Reel
Carries the pressurized water from the pump to the
gun and spray wand.
Spray Gun Handle
Connects with spray wand to control water flow rate,
direction and pressure. Equipped with Dial-N-Wash
pressure adjustment.
Loading ...
Loading ...
Loading ...