Loading ...
Loading ...
Loading ...
Operation
5
10Section 5 — operation
6. Swivel down the jack and crank jack down
further to take weight off the front wooden
shipping supports. With the weight off the
shipping posts, the wooden shipping supports
box can be removed. See Figure 5-3.
Figure 5-3
7. Remove ratchet tie down strap from rear of
trailer.
Thermal Relief Valve
When the temperature inside the pump rises too
high, this valve will open and release a gush of water
in an effort to lower the temperature inside the
pump. The valve will then close. See Figure 5-4.
Figure 5-4
Detergent Injection System
Mixes cleaners or cleaning solvents with the water to
improve cleaning effectiveness.
Water Supply
This unit is supplied with a water tank. Make sure the
water in the tank is clean as debris can cause excess
pump wear and reduce performance. Do not run dry.
WARNING: To reduce the possibility of
contamination always protect against
backflow when connected to a potable
water system.
Pressure Washer Operating Features
Pressure Adjustments
The pressure setting is preset at the factory to
achieve optimum pressure and cleaning. If you need
to lower the pressure, it can be accomplished by
these methods.
• Back away from the surface to be cleaned. The
further away you are, the less the pressure will
be on the surface to be cleaned.
• Change to the 40˚ nozzle (white). This nozzle
delivers a less powerful stream of water and
a wider spray pattern. Refer to “How To Use
Spray Wand”.
• Use the Dial-N-Wash to increase and decrease
the pressure. Refer to the “Dial-N-Wash
Adjustment” paragraph.
NOTICE: DO NOT attempt to increase pump
pressure. A higher pressure setting than the factory
set pressure may damage pump.
Transport and Setup
Make certain the trailer frame is securely balanced
before adjusting the position.
Do not to use jack stand on uneven surfaces and tires
should be blocked when lifting trailer off ball mount.
1. Secure the tow vehicle and trailer from rolling (by
blocking wheels) when operating jack.
2. These jacks are designed for vertical loading.
• Excessive side forces may cause jack failure and
must be avoided.
The jack is not intended to be used as a transport
device for the implement it is attached. Minimize
movement of implement while jack is under load.
NOTICE: TOW trailer as level as possible. DO NOT
operate on inclines.
Trailer Tongue Installation
1. Unfasten and unwrap tongue assembly from
trailer crate base.
2. Slide tongue assembly into slot located
under the front section of the trailer.
Figure 5-1
3. Slide light wiring through the tongue tube to
the front end.
4. Check trailer light wire routing through
tongue to make sure wires are not pinched,
stretched, tangled or hung up.
5. The hardware is located on the front wire
mesh tray. Mount tongue hardware through
the tongue support angles and tongue tube
and tighten. See below for reference on
correct installation of hardware provided.
Figure 5-2
To Tow the pressure washer:
WARNING! Do not tow faster than
55mph and check the local, state and
f
ederal requirements before towing on
any public road.
TONGUE SLOT
WOODEN SHIPPING SUPPORTS
½’’ LOCK NUT GRADE #8GRADE #8
½” FLAT WASHER GRADE #8
½” X 3-1/2” BOLT GRADE #8
Loading ...
Loading ...
Loading ...