Loading ...
Loading ...
Loading ...
• Holdthetrimmerheadparalleltoand
abovethegrassyarea.
• Tapthebottomofthetrimmerhead
lightlyonthegroundonetime.Ap-
proximately2 in.(5 cm)oflinewillbe
advancedwitheachtap.
Toadvance line,tapbottomoftrimmer
headongroundonetime.
Always tap the trimmer head on a
grassy area. Tapping on surfaces such
as concrete or asphalt can cause ex-
cessive wear to the trimmer head.
If lineisworn downto 2 in. (5 cm) or
less,more than one tap willbe required
to obtainthe most officiantline length.
WARNING" Use only .080" (2 ram)
diameter line. Other sizes o! line will
not advance properly and can cause
serious injury. Do not use other materi-
als such as wire, String, rope, etc. Wire
can break off during cutting and be-
come a dangerous missile that can
cause serious injury.
CUTTING METHODS
WARNING: Use minimumspeed and
do notcrowdthe linewhen cutting
around hard objects(rock, gravel, fence
posts,etc.),which can damage the trim-
mer head, become entan_ed inthe line,
or be thrown causing a serious hazard,
* The tipof the linedoes the curing.
Youwillachieve the best performance
and minimum linewear by notcrowd-
ingthe lineintocuttingarea. The right
and wrong waysare shown below.
Tipofthe Une LineCrowdedInto
DoesTheCutting WorkArea
Right
* The line willeasily remove grass and
weeds from around walls, fences,
trees and flower beds, but it also can
cut the tender bark of trees or shrubs
and scar fences. To help avoid dam-
age especially to delicate vegetation
or trees with tender bark, shorten line
to4-5 in. (10-13 cm) and use at less
than full throttle.
• For trimming or scalping, use less
than full throttleto increase line life
and decrease head wear, especially:
• During light duty cutting,
• Near objects around which the line
can wrap such as small posts,
trees or fence wire.
° For mowing or sweeping, use full
throttle for a goodclean job.
WARNING: Always wear eye protec-
tion. Never teen over the trimmer head.
Rocks or debris can ricochet or be
thrown intoeyes and face and cause
blindness or other serious injury.
TRIMMING - Hold the bottom of the
trimmer head about 3 in. (8
the ground and at an
the tip ofthe line to make contact.
notfome trimmer line intowork area.
Trimming
:3in. (8 cm)
AboveGround
SCALPING - The scalping technique
removes unwanted vegetation. Hold
the bottom of the trimmer head about 3
in. (8 cm) above the ground and at an
angle. Allow the tipof the line to strike
the ground around trees, posts, monu-
ments, etc. This technique increases
line wear.
Scelpi_o... .
MOWING - Your trimmer is ideal for
mowing in places conventional lawn
mowers cannot reach. In the mowing
position, keep the line parallel to the
ground, Avoid pressing the head into
the ground as this can scalp the
ground and damage the tool.
Mowing Ii
Loading ...
Loading ...
Loading ...