Loading ...
Loading ...
Loading ...
ENGLISH
10
SPEED SETTING APPROXIMATE SPEED OPM
1 8000
2 10000
3 12000
4 14000
5 16000
6 18000
(Actual OPM’s on your tool may vary.)
Be sure to select the proper speed for your oscillating tool
operation. If in doubt about the proper speed for your
operation, test the performance at low speed settings and
gradually increase until a comfortable speed is found.
Fig. I
2
Plunge Cutting
WARNING: Hold saw firmly with both hands for all
cutting operations.
WARNING: Inspect work area for hidden electrical
wiring, gas pipes or water pipes before making blind
or plunge cuts. Failure to do so may result in electrical
shock, fire, explosion, or property damage.
WARNING: ALWAYS use safety glasses. Everyday
eyeglasses are NOT safety glasses. Also use face or
dust mask if cutting operation is dusty. ALWAYS WEAR
CERTIFIED SAFETY EQUIPMENT.
WARNING: CUT HAZARD. Before cutting any type of
material, be sure it is firmly anchored or clamped to
prevent slipping.
WARNING: CUT HAZARD. Let the tool work at its own
pace. Do not overload, blade breakage may occur.
To Make a Cut
1. Clearly mark the desired cutting area.
2. Switch the tool on before applying pressure and
slowly feed the blade into the work piece at the
marked location.
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can causeinjury.
Versatrack Variables
1ST_Figure 1ST_Callout 2ND_Callout
J 11 12
WARNING: CUT HAZARD. Ensure the blade is not in
contact with cutting surface before starting saw.
3. Advance the blade along the cutting line until cut is
completed. Don’t force the tool; let the blade cut at its
own speed.
4. Switch the tool off.
NOTE:
Always use the appropriate type of saw blade for
the work piece material and type of cut. Cut only with sharp
blades; they cut cleaner, faster and put less strain on the
motor while cutting.
Sanding
WARNING: Fire hazard. When working on metal
surfaces, do not use a vacuum cleaner because
sparks are generated. Wear safety glasses and a
dust mask. Due to the danger of fire, do not use your
sander to sand magnesium surfaces. Do not use for
wetsanding.
NOTE: Do not rest fingers on platen during use. Move it in
long sweeping strokes across the surface, letting it do the
work. Light pressure is all that is required for sanding.
Helpful Hints
• Always ensure the work piece is firmly held or clamped
to prevent movement. Any movement of the material
may affect the quality of the cutting or sanding finish.
• Do not start sanding without having the sandpaper
attached to sanding platen.
• Use coarse grit paper to sand rough surfaces,
medium grit for smooth surfaces and fine grit for the
finishing surfaces. If necessary, first make a test run on
scrapmaterial.
• Excessive force will reduce the working efficiency and
cause motor overload. Replacing the accessory regularly
will maintain optimum working efficiency.
• Do not allow the sandpaper to wear away, it will
damage the sanding pad.
• If the tool overheats, especially when used at low speed,
set the speed to maximum and run it with no load for
2–3 minutes to cool the motor. Avoid prolonged usage
at very low speeds. Always keep the blade sharp.
Loading ...
Loading ...
Loading ...