Loading ...
Loading ...
Loading ...
Performance Data Sheet
SmartWaterFiltrationSystem
GWF/ HWFCartridge
Thissystemhasbeen testedaccordingtoNSF/ANS142/53forreductionofthesubstanceslistedbelow.
Theconcentrationoftheindicatedsubstancesin water enteringthesystemwas reducedtoa concentration
lessthanor equalto thepermissiblelimit for water leavingthesystem,as specifiedin NSF/ANS142/53.*
(100%safety factors built in for unmetered usage)
Par_rxzeter
Chlorine
T&O
Particulate**
Paratneter
'Ihrbidity
Lead at pH 6.5
Lead at pH 8.5
Lindane
atrazine
2,4-D
Asbestos
USEPA
MCL
Standard No. 42: Aesthetic Effects
Influent Effluent
Challenge Concentration Average Maximum
2.0 mg/L + 10% 0.02ppm 0.05 ppm
atleast10,000partides/mL 3,978 7,800
%Reduction Min.Required
Average Minimum Reduction
98.90% 97.37% > 50%
98.00% 96.10% > 85%
Standard No. 53: Health Effects
USEPA
MCL
1 NTU***
99.95% Reduction
15 ppb
15 ppb
0.0002 ppm
0.003 ppm
0.100 ppm
Influent
Challenge Concentration
11 + 1 NTU***
Minimum 50,(XI0 L
0.15 rag/L+ 10%
0.15 mg/L + 10%
0.002 mg/L + 10%
0.009 mg/L + 10%
0.210 rag/L+ 10%
10 _ to 1(_*fibet_/L;
fibers gtx:,ater than
10 micrometers in length
Effluent
Average Maximum
0.07 NTU 0.1 N_
26 55
1 ppb 1 ppb
1.8 ppb 4.3 ppb
0.00005 ppm 0.00005 ppm
0.002 ppm 0.003 ppm
0.042 ppm 0.090 ppm
0.32 MFL/ml 1.2 MFL/ml
% Reduction
Average Minimum
99.71% 99.59%
99.97% 99.95%
99.37% 99.37%
98.8% 97.13%
91.93% 91.93%
76.19% 64.28%
84.89% 67.63%
99.95% 99.82%
Min.Required
Reduction
0.5 NTU
> 99.95%
0.010 mg/L
0.010 mg/L
0.(R'I02mg/L
0.003 mg/L
0.07 mg/L
99%
* Testedusin2a flew rote of 0.52pro;pressureof60psig' pHof Z5"20.5;temp.of 20° +-Z5°C
** Measurementin Particles/mLParticlesusedwereO.&-Imicrons
*** NTU=NephelometricTurbidityunits
Operating Specifications
• Capacity: certified 1or up to 300 gallons (1135 l); up to six months for models without a replacement tilter indicator light; up to
one year for models with a replacement filter indicator light
• Pressure requirement: 40-120 psi (2.8-8.2 bar), non-shock
• Temperature: 33-100°F (0.6-38°C)
• Flow rate: 0.5 gpm (1.9 lpm)
General Installation/Operation/Maintenance Requirements
• Flush new cartridge at full flow for 3 minutes to purge out trapped air.
• Replace cartridge when 1low becomes too slow.
Special Notices
• Installation instructions, parts and smwice availability, and standard warranty are included with the product when shipped.
• This drinking water system must be maintained according to manufacturer's instructions, including replacement of filter
cartridges.
• Do not use with water that is microbiologically unsate or of unknown quality without adequate disinfection betore or after
the system. Systems certified 1or cyst reduction may be used on disinfected water that may contain filterable cysts.
• The contaminants or other substances removed or reduced by this water treatment system are not necessarily in your w-ateE
• Check 1or compliance with the state and local laws and regulations.
• Note that while the testing was performed under standard laboratory conditions, actual pertbrmance may vary. Systems must
be installed and operated in accordance with manufacturer's recommended procedures and guidelines.
System "Ik'sted and Certified by NSF international against ANSI/NSE Standard 42 & 53
tor the reduction off
Standard No. 42: Aesthetic Effects
Chemical Unit
'I_ste and Odor Reduction
Chlorine Reduction
Mechanical Filtration Unit
Particulate Reduction, Class i
Stamdaxd No. 53: Health Effects
Chemical Reduction Unit
Lead and Atrazine Reduction
Lindane and 2,4-D Reduction
Mechanical Filtration Unit
"Ihrbidily Reduction
C}<st and ,%sbestos Reduction
Manufactured tor: General Electric Company, Louisville, KY 40225
29
Loading ...
Loading ...
Loading ...