Loading ...
Loading ...
Loading ...
Using
the Master
Light switch
This feature turns off the lights in tile fresh
fbod and freezer compartments.
The s,Mtch is located behind the grille panel
at the top of the refrigerator. Lift up the panel
to access the switch.
Theswitch is lecated
behindthegriEEepanel.
Type 1 bulb
,_placement
NOTE: Before replacing tile bulbs, review
the light bulb information and WARNING
on page 20.
Replacing Type 1 bulbs located in lamps
behind the top pan in the fresh food
compartment and the bottom freezer basket
in the freezer compartment:
1. Set the Master Light s,Mtch to the OFF
position (see Using the Master L{ght switch)
and allow the lamps to cool.
2. To access tile lamps in the fresh food
compartment, remove tile top pan.
See Drawer and Pan Removal section.
To access the lamps in the freezer
compartment, remove the bottom freezer
basket. See Freezer Baskets section.
3,
On the back wall there is a curved light
shield. Grasp each end of the light shield.
Pull the shield reward you and the tabs
on the shield will release from the slots in
the housing.
4. Remove the glass above the bulbs by pulling
it straight out.
NOTE: Al,a-aysfollow bulb manufacturer's
directions for handling and replacing bulbs.
5. Remove the bulb by holding the base and
pulling straight up. Replace with a new bulb.
6. Replace the glass hy sliding it into place.
Then replace the light shield by resting the
top lip of the shield on top of the light
housing. Then press the sides until the tabs
pop into the slots in the housing.
WARNING - Thelight shieldmust
be replaced or the heat from the bulb could
damage the refrigerato*:
AVERTISSEMENT :
Vous devez remettre en place l'_cran 'a lumi_re
pour ne pas endommager votre rdfrigdrateur
avec la chaleur produite par l'ampoule.
7. Reset the Master Light switch to the ON
position.
21
Loading ...
Loading ...
Loading ...