Loading ...
Loading ...
Loading ...
8
2
Pass the thread under the thread guide and
around the pretension disk, front to back�
Pretension disk
3
Passing the thread through a hole on the bobbin,
set the bobbin on the bobbin winder shaft, and
then slide the shaft to the right�
Make sure the notch fits the projection�
Bobbin winder shaft
Projection
Notch
Memo
• Checking the orientation of the bobbin will
be helpful in later procedures� By placing
the bobbin into the bobbin case in the same
orientation that it was on the bobbin winder
shaft, the bobbin can be installed with the
correct winding direction of the bobbin thread�
The “b” mark on one side of the bobbin
included with this machine can be used as a
reference�
Bobbin case
4
Turn on the machine�
5
While holding the end of the thread, start the
machine to wind the thread around the bobbin a
few times�
or
Depress
gently�
7-8 cm
★
6
Stop the machine and trim the excess thread�
Release�
or
★
7
Slide the sewing speed controller to adjust the
bobbin winding speed� ★
Slower
★
Faster
8
Start the machine�
Depress�
or
★
Note
• We recommend winding stretch thread, such as
transparent nylon thread, at a low speed since
the thread may stretch�
9
When the bobbin seems full and
begins spinning slowly, stop the
machine�
10
Cut the thread, slide the bobbin winder shaft to
the left and remove the bobbin�
CAUTION
• Make sure you follow the instructions
carefully� If you do not cut the thread
completely and the bobbin is wound, when
the thread runs low, it may tangle around the
bobbin and cause the needle to break�
• Not winding the bobbin
properly may cause the
thread tension to loosen,
and may break the needle�
11
Raise the needle to its highest position, and then
raise the presser foot lever�
Turn toward you�
★
or
12
Turn off the machine�
13
Open the bobbin cover�
ON
OFF
★: Only for some models�
Loading ...
Loading ...
Loading ...