Loading ...
Loading ...
Loading ...
10
2
Raise the needle to its highest position�
Turn toward you so that this mark
points up to the highest position�
Press once or twice�
or
★
3
If the power of the machine is on, turn it off�
4
Pull up the spool pin as far as
possible, and put a spool of
thread on this pin�
Make sure that the thread
unwinds as shown�
5
Pass the thread through the thread channel in the
order shown below�
*
Follow the numbered path printed on the machine�
Thread take-up lever
Make sure that the thread
unwinds as shown�
6
Slide the thread behind
the needle bar thread
guide�
7
Insert the thread through the eye of the needle
from front to back, and then pass the thread
under the presser foot�
10 cm (4 inches)
n Using the needle threader ★
CAUTION
• The needle threader can only be used with
home sewing machine needles size 75/11-
100/16� If you are using transparent nylon
monofilament thread, you can only use
needles in the range of 90/14-100/16�
• You cannot use the needle threader if you
are using decorative threads or special
needles, such as the twin needle and wing
needle� If you are using those types of
threads or needles, thread the eye of the
needle by hand� Make sure the main power
switch is off when threading the needle�
1
Follow steps 1 to 6 of “Upper threading”�
2
<Type A>
a) Pass the thread behind the guide (1), and
insert the thread into the slit of the thread
guide disk (2) firmly� Next, cut the thread
with the thread cutter (3)�
2
1
3
Thread cutter
Guide
Thread guide
disk
b) Lower the presser foot lever�
c) Lower the needle threader lever fully until
it stops (4), and push it back slowly until it
stops (5)�
5
4
Hook
*
Make sure that the hook passes through the
eye of the needle, and catch the thread�
<Type B>
a) Lower the presser foot lever�
Needle bar thread guide
★: Only for some models�
Loading ...
Loading ...
Loading ...