Loading ...
Loading ...
Loading ...
Yourcleaningsystemrequiressomeassemblyandisready
foruseonlyafterit hasbeenproperlyservicedwiththe
recommendedoilandfuel.
If you have any problemswith the assemblyof your
pressurewasher, please call the pressurewasher heipline
at 1-800-222-3135.
UNPACKTHE PRESSUREWASHER
8. Attach nozzleextension to spray gun.
9. Select/attachquick connect spray tip to nozzle extension.
Attach Handle and Cleaning Tank
1. Placehandle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with holes
(C) on handle supports.
1. Remove everything from carton except pressure washer.
2. Opencarton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTONCONTENTS
Checkall contents, if any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
* Main Unit
* Handle
* Cleaning TankAssembly
* High PressureHose
* Spray Gun
* NozzleExtensionwith Quick Connect Fitting
* Oil Bottle
* DetergentSiphoning Hose/Filter
* Parts Bag (which includes the following):
* Operator's Manual
* Owner's Registration Card
* Safety Goggles
* Gun Holder Wireform
* Bagcontaining 4 multi-colored Spray Tips
* HandleFasteningHardwareKit (whichincludes):
* Carriage Bolts (2)
* "L" Bolt
* Plastic Knobs (4)
, Tree Clips (4)
Becomefamiliar with each piece before assembling the
pressure washer, identify all contents with the illustration on
page 6. If any parts are missing or damaged,call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLINGCLEANINGSYSTEM
Your Craftsman cleaning system will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handleand cleaning tank.
3. Connect detergent siphon hose to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect pressure hose to spray gun and pump.
7. Connect water supply to pump.
NOTE:It may be necessaryto move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts (A) through holes from back of unit
and attach a plastic knob (B) from front of unit. Tighten
by hand.
Placecleaning tank (B) over holes (C) on handle
(viewing from front of unit). Push the tree clips (A) into
the holes until they sit flat against the cleaning tank.
"-.
/,
Insert "L" bolt (A) through hole just abovecleaning tank
on right side of handle (viewing from front of unit). Hold
bolt in place and attach plastic knob (B) from inside of
unit. Tighten by hand.
Loading ...
Loading ...
Loading ...