Loading ...
Loading ...
Loading ...
Check High Pressure Hose
High pressure hoses can develop leaks from wear, kinking,
or abuse. Inspect hose before each use. Checkfor cuts,
leaks, abrasions, bulging of cover, or damage or movement
of couplings. If any of these conditions exist, replace hose
immediately.
WARHIHG
The high pressure stream of water that this
_ quipment produces can cut through skin and its
underlying tissues, leading to serious injury and
_ossibleamputation.
* NEVERrepairhighpressurehose.Replaceit.
* ReplacementhoseratingMUSTexceedmaximumpressure
ratingof unit.
Check Spray Gun
Examinehoseconnectionto spraygun and makesure it is
secure.Testtrigger by pressingit and makingsure it springs
backinto placewhenyou releaseit. Do not depressred button
andtest trigger. Youshould not be ableto presstrigger. Replace
spraygun immediatelyif it fails any of these tests.
HozzleMaintenance
A pulsing sensation felt while squeezingthe spray gun trigger
may be caused by excessive pump pressure. The principal
cause of excessive pump pressure is a spray tip clogged or
restricted with foreign materials, such as dirt, etc. To correct
the problem, immediately clean the spray tip following these
instructions:
1. Shut off engine and turn off water supply.
2. ALWAYSpoint spray gun in a safe direction, press red
button and and squeezespray gun trigger to release
retained high water pressure.
WARHIHG
The high pressure stream of water that this
equipment produces can cut through skin and its
_ nderlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
* Keephighpressurehoseconnectedto pumpandspraygun
whilesystemis pressurized.
* ALWAYSpointspraygun in safedirection,pressredbutton
andsqueezespraygun trigger,to releasehighpressure,every
time youstop engine.
3. Removespray tip from end of nozzleextension.
4. Usea small paper clip to free any foreign material
clogging or restricting spray tip (A).
,
6.
Remove nozzleextension from spray gun.
Using a garden hose, remove additional debris by back
flushing water through nozzle extension. Back flush
between30 to 60 seconds.
J
7. Reinstall spray tip into nozzleextension.
8. Reconnectnozzle extension to spray gun.
9. Makesure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
10. Start engine following instructions How to Start Your
Pressure Washer.
11. Test pressure washer by operating with each quick
connect spray tip.
O-Ring Maintenance
Purchasean O-Ring RepairKit at your local Searsor by calling
1-880-4-MY-HONIE(469-4663) or online at www.sears.com. It
is not includedwith the pressurewasher.Thiskit includes
replacemento-rings, rubberwasherand water inletfilter. Referto
the instructionsheetprovidedin the kit to serviceyour unit's
o-rings.
WARHIHG
The high pressurestream of water that this
,p_ equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
)ossible amputation.
* NEVERrepairleakingconnectionswith sealantof anykind.
Replaceo-ring or seal.
17
Loading ...
Loading ...
Loading ...