Loading ...
Loading ...
Loading ...
QUESTIONS AND ANSWERS
Operation
Question Answer
What is wrong when the oven light wilt not There may be several reasons why the oven light will not glow.
gbw during cooking? Perhaps;
'SuCooking time has not been set,
.fuSTART has not been touched,
;rUThe light bulb is burned out.
Why does steam come out of [he air Steam is normal_y produced during cooking. The microwave even
exhaust vent? has been designed to vent this steam.
Will the microwave oven be damaged if it Yes. Never operate the oven empty or without the glass turntable,
operates empty?
Does microwave energy pass through the No. The metal screen bounces the energy back to the oven cavity.
viewing screen in the door? The holes (or ports) only allow light to pass through, They do not let
microwave energy pass through.
Why does the beep sound when a pad on The beep tells you that the setting is properly entered.
the control panel is touched?
Can my microwave oven be damaged if Like any other cooking appliance, it is possible to overcook food to
food is cooked for too long? the point where the food creates smoke and even possibIy fire
damage to the inside of the oven. It is always best to be near the
oven while it is in the cooking process.
When the oven is plugged into wall outtet for ]-he microcomputer contro{ling your oven may temporarily become
the first time, it might not work properly, scrambled and fail to function as programmed when you plug ]n for
What is wrong? the first time or when power resumes after a power interrupt}on,
Unplug the oven from the 120 volt household outtet and then plug it
back in to reset the microcomputer.
Why do I see light reflection around the This light is from the oven light which is located between the oven
outer case? cavity and the outer walt of the oven.
What are the various sounds t hear when The clicking sound is caused by a mechanical switch turning the
the microwave oven Lsoperating? microwave oven's magnetron ON and OFF.
The heavy hum and clunk is from the change in power the
magnetron draws as it is turned ON and OFF by a mechanical
switch.
The change in blower speed isfrom the change in line voltage
caused by the magnetron being turned ON and OFF.
-21 -
Loading ...
Loading ...