Loading ...
Loading ...
Loading ...
If the unit still doesn't start, refer to the
TROUBLESHOOTING TABLE or call
1-800-235-5878.
OPERATING THE COUPLER
This model is equipped with a coupler
which enables optional attachments to
be installed. The optional attach-
ments are:
Edger ................. 358.792401
Cultivator .............. 358.792410
Blower ................ 358.792421
Brushcutter ............ 358.792441
Pruner ................ 358.792450
WARNING: Always stop unit
and disconnectspark plug before re-
moving or installing attachments.
REMOVING TRIMMER ATrACH-
MENT (OR OTHER OPTIONAL AT-
TACHMENTS)
CAUTION: When removing or instal-
ling attachments, place the uniton a
flat surface for stability.
1. Loosen the couplerby turning the
knob counterclockwise.
Upper Shaft
Coupler
Lower
Attachment
.OOSEN
TIGHTEN Knob
2. Press and holdthelocking/release
button.
Locking/Release
Button
/
Lower Attachment
Upper Shaft
3. While securely holding the engine
and upper shaft, pull the attach-
ment straight out of the coupler.
INSTALLING OPTIONAL ATTACH-
MENTS
1. Remove the shaft cap from the at-
tachment (if present).
2. Position locking/release button of
attachment into guide recess of
coupler.
3. Push the attachment into the cou-
pler until the locking/release button
snaps into the primary hole.
4. Before using the unit, tighten the
knob securely by turning clock-
wise.
Coupler PrimaryHole
Upper Locking/ Attachment
Shaft Release
Button
_'WARNING: Make sure the lock-
ing/release buttonis locked in the pri-
mary hole and the knob is securely
tightened before operating the unit.
OPERATING POSITION
ALWAYS WEAR:
Eye Protection
Long Pants
Heavy Shoes
Cut only from your rightto your left.
_1_ WARNING: Always wear eye
protection. Never lean over the tnm-
mer head. Rocks or debris can rico-
chet or be thrown into eyes and face
and cause blindness or other serious
injury.
When operating unit, stand as shown
and check for the following:
• Wear eye protection and heavy
clothing.
• Hold trigger handle with right hand
and assist handle with left hand.
• Keep unit below waist level.
• Cut only from your right to your left
to ensure debris is thrown away
from you. Without bending over,
keep line near and parallel to the
ground and not crowded into materi-
al being cut.
Do not run the engine at a higher
speed than necessary. The cutting
line will cut efficiently when the engine
is run at less than full throttle. At lower
speeds, there is less engine noise and
vibration. The cutting line will last
longer and will be less likely to '_veld"
onto the spool.
Always release the throttle trigger and
allow the engine to return to idle
speed when not cutting.
12
Loading ...
Loading ...
Loading ...