Loading ...
Loading ...
Loading ...
13
Drain Air Gap
Storing
Troubleshooting
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call.
In the U.S.A., www.kitchenaid.com In Canada, www.kitchenaid.ca
Some state or local plumbing codes require the addition of a drain air gap between a
built-in dishwasher and the home drain system. Check the drain air gap when your
dishwasher is not draining well.
The drain air gap is usually located on top of the sink or countertop near the dishwasher.
NOTE: The drain air gap is an external plumbing device that is not part of your
dishwasher. The warranty provided with your dishwasher does not cover service costs
directly associated with the cleaning or repair of the external drain air gap.
To clean the drain air gap
Clean the drain air gap periodically to ensure proper drainage of your dishwasher. With
most types, you lift off the chrome cover. Unscrew the plastic cap. Then check for any
soil buildup. Clean if necessary.
Storing for the summer
If your dishwasher is not in use during the summer months, turn off the water supply and
power supply to the dishwasher.
Storing for the winter
Avoid possible water damage to your home and dishwasher due to freezing water lines.
If your dishwasher is left in a seasonal dwelling or could be exposed to near freezing
temperatures, have your dishwasher winterized by authorized service personnel.
PROBLEM SOLUTION
DISHWASHER DOES
NOT RUN
NOTE: It is normal for the dishwasher to repeatedly pause several times during a cycle.
If the Start/Resume light is blinking, close the door and push START/RESUME.
Be sure the door is closed and latched.
Check that there is not an interference with large casserole dishes and the wash system at the
back of the dishwasher. Adjust loading as necessary to ensure door is closed and latched.
Be sure you have selected a cycle. (See “Cycles and Options Descriptions” section.)
Be sure there is power to the dishwasher. A circuit breaker or fuse may have tripped.
If lights other than Start/Resume blink and the unit will not run, you will need to call for service.
DETERGENT REMAINS IN
THE DISPENSER OR
TABLET IS ON BOTTOM
OF TUB
Check for dishware such as cookie sheets, cutting boards, or large containers, etc., that may be
blocking the detergent dispenser from opening properly.
Be sure your detergent is fresh and lump free.
Be sure the cycle has completed (the Clean light is on). If it has not completed, you will need to
resume the cycle by closing the door and pressing START/RESUME.
CYCLE RUNS TOO LONG NOTES:
■ To use less water and reduce energy consumption you will encounter cycles that typically run
for up to 3 hours.
■ A water heater setting of 120°F (49ºC) is best, the dishwasher will delay longer while heating
cooler water.
■ Some options will add time to the cycle. (See “Cycles and Options Descriptions” section.) The
Heat Dry option adds approximately ½ hour.
Try the 1 Hour Wash cycle.
Run the hot water at a faucet close to the dishwasher before starting the cycle.
DISHWASHER NOT DRYING NOTE: Plastic and items with nonstick surfaces are difficult to dry because they have a porous
surface which tends to collect water droplets. Towel drying may be necessary.
Use of rinse aid along with the Heat Dry option is needed for proper drying.
Proper loading of items can affect drying. (See specific loading instructions within this guide.)
Glasses and cups with concave bottoms hold water. This water may spill onto other items when
unloading.
■ Unload the bottom rack first.
■ Locate these items on the more slanted side of the rack for improved results.
Downloaded from www.ManualsFile.com manuals search engine
Loading ...
Loading ...
Loading ...