Loading ...
Loading ...
Loading ...
INSTALLATION STEP 6
Install the DoorControl
Locate door control within sight of door, at a minimum height of
5 feet (1.52 m) where small children cannot reach,away from
moving parts of door anddoor hardware.
1. Strip 1/4" (6 mm) of insulation from one end of bell wire and
connect to the two screw terminals on back of door control by
color: white wire to 2 and white/red wire to the 1.
2. Fastenthe door control button securely with 6ABx1-1/2"
screws. If installing into drywall, drill 5/32" holes and use the
anchors provided.
3. Run bell wire up wall and across ceiling to motor unit. Use
insulated staples to securewire in several places. Do not pierce
wire with a staple, creating a short or opencircuit.
4. Strip 7/16" (11 mm) of insulation from end of bell wire. Connect
the bell wire to the terminal screws on the motor unit panel:
white to 2; white/red to 1.
5. Position the antenna wire as shown.
6. Usetacks or staples to permanently attach entrapment warning
label to wall near door control, and manual release/safety
reversetest labelin a prominent location on inside of garage
door.
NOTE:DONOT connect the power and operatethe opener at this
time. The trolley will travel to the furl open position but will not
return to the closeposition until the sensor beam is connected
and properly aligned.
To prevent possible SERIOUSINJURYor DEATHfrom
electrocution: parts of door.
• Besure power is NOTconnected BEFOREinstalling door
control.
• ConnectONLYto 24 VOLT low voltagewires.
To prevent possible SERIOUSINJURYor DEATHfrom a closing
garage door:
• Install door control within sight of garage door, out of reach
of children at a minimum height of 5 feet (1.5 m), and away
from ALL moving parts of door.
• NEVERpermit children to operate or play with door control
push buttons or remote control transmitters.
• Activate door ONLYwhen it can be seenclearly, is properly
adjusted, andthere are no obstructions to door travel.
• ALWAYS keepgaragedoor in sight until completely closed.
NEVERpermit anyoneto cross path of closing garage door.
HARDWARESHOWN ACTUALSIZE
Screw 6ABx1-1/2" Drywall Insulated
Lighted Door Control Button Anchors Staples
Opener Terminal Screws
Terminal
Screws
(BACKVIEW)
DOORCONTROLBUTTON
BackPanel of Opener _
Antenna
17
Loading ...
Loading ...
Loading ...