Loading ...
Loading ...
Loading ...
k
PROBLEM
Loss of power
TROUBLESHOOTING CHART
CAUSE '
• Rear oflawn mower housing
or cuttingblade dragging
in heavy grass.
• Cut_ng too much grass.
Poor cut- uneven
Excessive
vibration
Starter rope hard
to pull
Grass catcher
not filling (rfso
equipped)
Hard to push
• Dirtyair filter.
• Buildupofgrass, leaves,
and trash under mower.
• Too much oilin engine.
• Walking speed too fast.
•Wom, bent or loose blade.
• Wheel heights uneven.
• Buildup of grass, leaves
and trash under mower.
•Wom, bent or loose blade.
• Bent engine crankshaft.
• Engineflywheelbrake ison
whencontrolbarisreleased.
• Bent engine cranksl_ft
• Blade adapter broken.
• Blade dragging in grass.
• Cuttingheight too low.
• Lifton blade wom off.
• Catcher not venting air.
• Grass istoo highor wheel
height istoo low.
• Rear of lawn mower
housing or blade dragging
in grass.
• Grass catcher too full.
• Handle height positionnot
rightfor you.
CORRECTION
• Set to "Higher Cut"
position.
• Bet to "Higher Cut"
position.
• Clean/replace air filter.
• Clean underside of mower
housing.
• Check oil level.
• Cut at slowerwalking
speed.
• Replace blade. T_hten
blade bolt.
• Set all wheels at same
height
• Clean underside of
mower housing.
• Replace blade. Tighten
blade bolt.
• Contact an authorized
sewice center.
• Depress controlbarto
upper handle before
pullingstarter rope.
• Contact an authorized
se_,ice center.
• Replace blade adapter.
• Move lawn mower to cut
grass or tohard surface
• Raise cutting height.
• Replace blade.
• Clean grass catcher.
• Raise cutting height.
• Raise rear oflawn mower
housing one (1) setting
higher.
• Empty grass catcher.
• Adjust handle height to
suit.
15
Loading ...
Loading ...
Loading ...