Loading ...
Loading ...
Loading ...
, Select a suitable location for the dryer on a hard even surface away from
direct sunlight or heat sources, baseboard heaters, cooking appliances etc.
Any floor unevenness should be corrected with leveling legs located on the
bottom of the dryer.
Tooms and materi ls required
" Phillips head and flathead screwdrivers
. ChanneHock adjustable pilers
* 1/2 inch open end wrench
* Carpenter's level
" Measuring tape (] 2ft. min.)
* Duct tap
* Rigid or flexible metal 4 inch (t 02cm) duct
° Vent hood
Emectric m requirements
U.S. Only
Power supply:
3 or 4 wire, 240 Volt, 30 Amp,60Hz, 1 Phase Power Supply Cord Kit (not
supplied when sold in the United States) - Purchase to meet local electrical codes.
The dryer MUST employ a 3-conductor power supply cord NEMA ] 0-30 Type
SPDTRATEDAT 240 Volt AC minimum, 30 Amp., with 3 open end spade lug
connectors with upturned ends or closed loop connectors and marked for use with
clothes dryers. If being installed in a manufactured (mobile) home,the dryer MUST
employ a 4-conductor power supply cord. NEMA ]4-30 type SRDT or ST (as
required) rated at 240 Volt AC Minimum, 30 Amp., with 4 open end spade lug
connectors with upturned ends or dosed loop connectors and marked for use with
clothes dryers. See Electrical Connections for A 4-Wire System.
Canada On|y
Candian models are supplied with the appropriate power cord.
Unpacking Your Dryer
1. Remove all packaging material. This includes the foam base and all adhesive
tape holding the dryer accessories inside and outside.
2. Inspect and remove any remains of packaging, tape or printed materials
before using the dryer.
4
Loading ...
Loading ...
Loading ...