Loading ...
Loading ...
Loading ...
No tools required for ass_bly.
Attach handle to vacuum
Locate the vacuum base and the handle. Stand
the vacuum base upright and slide the handle
into the opening at the top of the vacuum base.
The handle will click into place at the highest
height setting.
NOTE: The handle has two height settings.
To lower or raise the handle, push the handle
height adjustment button (designated by the
corresponding icon pictured below) and slide
the handle up or down until it locks into place.
AWARNING
Donotpluginyourvacuumcleaneruntil
youarefamiliarwithallinstructionsand
0peBtingpr0cedure_
AWARNING
Plasticfilmcanbedangerous,Toavoid
dangerofsuffocation,keepawayfrom
babiesandchildren.
Attach vacuum hose and tools
1. Attach the Twist n' Snap TM hose by lining up
the tabs on the hose cuff with the corresponding
notches on the back of the vacuum. Twist the
hose cuff clockwise to lock the hose into place.
2. Slide the end of the hose wand into the hose
wand base and fold the hose over the upper
hose wrap.
NOTE: The powerfoot will not operate effective-
ly unless the hose isfirmly attached to the base.
3. Slide the crevice tool/extension wand holder
onto the lower mount on the back of the
vacuum as shown. Snap the crevice tool into
the tool holder.
4. Slide the specialty tool holder onto the upper
mount on the back of the vacuum as shown.
Snap the TurboBrush Tool into the tool holder.
5. Wrap the power cord around the cord
wrap clips.
Power switch/brush switch
The power switch is located just below the handle
on the front of the detachable pod. Push the
switch once to turn the vacuum on and again to
turn the vacuum off when cleaning is complete.
The brush roll power switch is located just below
the handle on the front of the detachable pod
above the power switch. This switch turns the
rotating brush power on and off. The switch will
glow when activated.
NOTE; The brash roll power will automatically
shut off whenever the vacuum is locked in
its upright position. The switch will continue
to glow if left on in the upright position or if
the pod is detached from the vacuum base,
although the brush will not reactivate until the
pod is attached and the vacuum is detented.
power
ACAUTION
Beforeusingy0urvacuum,makesurethat
thedirtcontainerisinlockedpositionand
thatallfilters(pre-m0t0randp0st-m0t0r)
areinplace.Donotoperateyourvacuum
withoutthesefilters.
www.BISSELL.(
brush
Loading ...
Loading ...
Loading ...