Loading ...
Loading ...
Loading ...
Problem
Vacuum
cleaner won't
tum on
No power at
rotating floor
brush
Vacuum
cleaner won't
pick up dirt
Possible causes
Power cord not plugged in
Blown fuse/tripped breaker
Pod is not securely seated
Brush switch turned to "OFF"
Vacuum is in upright position
Hose not attached to suction
opening
Crack or hole in hose
Broken or worn drive belt
Remedies
Check electrical plug
Check/replace fuse or reset
Remove pod and replace, makin
sure that it "clicks" into place
Make sure brush switch is in "ON" pos
Recline vacuum to operate brush
Grasp quick reach handle and firmly
hose wand onto the suction opening
Check hose and replace if needed
Replace drive belt, see pages 10, 11
Rotating floor brush jammed
Clog in vacuum
Dirt container or secondary
cyclone not installed properly
Filters are dirty
Remove brush and clean debris from
brush ends
Follow instructions on page 12 for
clearing clogs
Position correctly and lock in place
Check and clean pre-motor and
post-motor filters, see page 9
Visible dirt
escaping
from cleaner
Filters or secondary cyclone Check secondary cyclone, pre-motor and
missing or installed incorrectly post-motor filters for correct installation
Dirt container installed incorrectly Pull out and re-insert dirt container
correctly
Please do
not return
this product
to the store.
Other maintenance or service not included in the manual should
performed by an authorized service representative.
Thank you for selecting a BISSELL product.
For any questions or concerns, BISSELL is ha
be of service. Contact us directly at 1-800-
www.BISSELL._
Loading ...
Loading ...
Loading ...