Loading ...
Loading ...
Loading ...
STARTING AND OPERATING 195
N (NEUTRAL) Button
6. After the shift is completed and the N
(NEUTRAL) light stays on, release the N
(NEUTRAL) button.
7. Shift the transmission into REVERSE or DRIVE.
8. Release the brake pedal for five seconds and
ensure that there is no vehicle movement.
9. Press and hold the brake pedal. Shift the
transmission back into NEUTRAL.
10. Apply the Electric Park Brake.
11. With the transmission and transfer case in N
(NEUTRAL), push and hold the ENGINE START/
STOP button until the engine turns off. Ensure
the vehicle is in the RUN position with the
engine off.
12. Place the transmission gear selector in PARK.
Release the brake pedal.
13. Attach the vehicle to the tow vehicle using a
suitable tow bar.
14. Release the Electric Park Brake. Ensure the
vehicle is in the RUN position with the engine
off.
15. Push the ENGINE START/STOP button twice
(without pressing the brake pedal), to turn the
ignition to the off position.
Shifting Out Of Transfer Case N (NEUTRAL)
Use the following procedure to prepare your
vehicle for normal use:
1. Bring the vehicle to a complete stop, leaving
it connected to the tow vehicle.
2. Apply the Electric Park Brake.
3. Start the engine.
NOTE:
Steps 1 through 5 are requirements that
must be met before pushing the N
(NEUTRAL) button, and must continue to be
met until the shift has been completed.
If any of these requirements are not met
before pushing the N (NEUTRAL) button or
are no longer met during the shift, the N
(NEUTRAL) indicator light will flash continu-
ously until all requirements are met or until
the N (NEUTRAL) button is released.
The ignition must be in the ON/RUN position
for a shift to take place and for the position
indicator lights to be operable. If the ignition
is not in the ON/RUN position, the shift will
not take place and no position indicator
lights will be on or flashing.
A flashing N (NEUTRAL) position indicator
light indicates that shift requirements have
not been met.
4. Press and hold the brake pedal.
5. Shift the transmission into NEUTRAL.
6. Using a ballpoint pen or similar object, push
and hold the recessed transfer case N
(NEUTRAL) button (located by the selector
switch) for one second.
N (NEUTRAL) Button
4
22_WL_OM_EN_USC_t.book Page 195
Loading ...
Loading ...
Loading ...