Loading ...
Loading ...
Loading ...
Answer by voice command
This feature allows you to answer incoming
calls automatically with your voice. When your
voice is detected, answered calls will
automatically be directed to the speakerphone
mode. The default setting is “Off”.
Important:
R Before using this feature, we recommend
that you test it and adjust the voice
command sensitivity as needed.
R For best performance, answer the call
within a range of 50 cm (20 inches) to 1 m
(40 inches).
R Once this feature is turned on, the Talking
Caller ID will be activated automatically. To
turn off the Talking Caller ID feature, see
page 38.
R Ambient noise (dog barking, TV sound,
etc.) may cause the unit to answer an
incoming call.
R When this feature is used, the unit
disconnects the call automatically after 3
minutes. You may hear a warning tone and
the unit may prompt you to press * to
continue talking 1 minute before
disconnecting.
R Once you press any key operations during
a call, the call is continued.
Note:
R When a call is manually answered using a
unit, voice detection will end, and the
answer by voice command feature stops
operating.
R This feature is not available while baby
monitor is set to “On” (page 41).
R The speaker of the handset responds even
if the headphones are connected.
Turning answer by voice command
on/off
1 Press and hold * for about 2 seconds.
2 MbN: Select the desired setting. a
MSAVEN
R If you selected “Off”, go to step 4 to
exit.
3 MYESN a The unit will display and
announce the voice command guidance.
R We recommend answering calls as
demonstrated.
R There must be a 1 second pause
between the two phrases.
4 To stop: Press MSTOPN.
To playback: Press MYESN.
To exit: Press MOFFN.
Note:
R If you wish to turn on answer by voice
command feature, select “Tone 1” to
“Tone 5” as your ringer tone (page 38).
If another ringer tone is selected, the unit
will automatically use “Tone 1” as the
default ringer tone.
Answer by voice command sensitivity
You can adjust the sensitivity of the answer by
voice command. Increase or decrease the
sensitivity to adjust the sound level needed to
trigger the answer by voice command feature.
1 MMENUN#107
2 MbN: Select the desired setting. a
MSAVEN a MOFFN
Answering calls
1 When the unit rings, speak clearly as
demonstrated by the voice guidance.
Refer to step 3, “Turning answer by voice
command on/off”, page 25.
2 When you finish talking, press MOFFN.
For assistance, please visit http://shop.panasonic.com/support
25
Answer by Voice Command
Loading ...
Loading ...
Loading ...