Loading ...
Loading ...
Loading ...
5. 5
AttachtheLatchHousing(73)tothebft Upright
(84)withtwoScrews(3);startbothScrews
andthentightenbothScrews.Makesurethat
thetargeholein theLatchHousingisonthe
indicatedside.
Removetheknobfromthepin.Makesurethat
thecollarandthespringareonthepin.(Note:if
therearetwocollars,placeoneoneachsideof
thespring.)insertthepinintotheLatchHousing
(73).Then,tightentheknobontothepin.
MakesurethataHpartsareproperlytightenedbeforeyouusethetreadmill iftherearesheetsofclear
pUastbonthetreadmHUdecab,removethepUastb.Toprotectthefloororcarpet,pUaceamatunderthetread°
mill Note:Extrahardwaremaybeincluded.KeeptheincludedhexkeyinasecurepUace;theUargehexkeyis
usedtoadjustthewaUMngbeUt(seepage19).
if you purchase the optional chest puJse sensor (see
page 18}, follow the steps below to instatt the receiver
included with the chest pulse sensor.
1. Make sure that the power cord is unplugged. Remove
the indicated Screw (3) and the Access Door (76) from
the back side of the Consob Base (85).
2. Connect the wire on the receiver (A) to the indicated wire
extending from the Console Base (85). Hold the re-
ceiver so the small cylinder is oriented as shown and
is facing the Console Back. Attach the receiver to the
plastic posts on the Access Door (76) with the two in-
cluded small screws.
3. Make sure that no wires are pinched. Reattach the
Access Door (76) with the Screw (3). Discard the other
wires included with the receiver.
8
Loading ...
Loading ...
Loading ...