CM61081-S User Manual

Loading ...

19 - ENG

5. Squeeze bottle to inject contents intopump.

6. With ignition switch off, simultaneously pull starter rope and squeeze bottle.

Repeat until protector fluid exits pump outlet. NOTE: This step may require

twopeople.

PRESSURE WASHER

1. Drain all water from high pressure hose and wrap it onto hosewrap.

2. Drain all water from the spray gun and wand by holding spray gun in a

vertical position with nozzle end pointing down and squeezing trigger. Store in

gunholder.

3. Wrap up and secure detergent siphon hose so it is protected fromdamage.

ACCESSORIES

DANGER: Risk of fluid injection. When using replacement spray wands

or guns with this pressure washer, DO NOT use a spray wand and/or spray

gun/wand combination that is shorter in length than what was provided with

this pressure washer as measured from the nozzle end of the wand to the

guntrigger.

NOTICE: The use of any other accessory not recommended for use with this tool

could be hazardous. Use only accessories rated equal to or greater than the rating

of the pressurewasher.

SERVICE INFORMATION

Do not return this product to your retailer. Please contact our customer service

department at www.simpsoncleaning.com

LIMITED WARRANTY

The manufacturer of this product agrees to repair or replace designated parts that

prove defective within the warranty period listed below at the manufacturer’s sole

discretion. Specific limitations/extensions and exclusions apply.

This warranty covers defects in material and workmanship and not parts failure

due to normal wear, depreciation, abuse, accidental damage, negligence, improper

use, maintenance, water quality or storage. To make a claim under the terms of

the warranty, all parts said to be defective must be retained and available for return

upon request to a designated Warranty Service Center for warranty inspection. The

judgments and decisions of the manufacturer concerning the validity of warranty

claims are final.

These warranties pass through to the end user and are non-transferable. As a

factory authorized and trained Warranty Service Center, the factory will honor the

terms of all component warranties and satisfy claims of the appropriate warranty

provisions.

Normal wear items include, but are not limited to, valves and seals, which are not

covered by this warranty.

This warranty replaces all other warranties, express or implied, including without

limitation any warranties of merchantability or fitness for a particular purpose and

all such warranties are hereby disclaimed and excluded by the manufacturer. The

manufacturer’s warranty obligation is limited to repair and replacement of defec-

tive products as provided herein and the manufacturer shall not be liable for any

further loss, damages, or expenses – including damages from shipping, accident,

Loading ...

User Manual - Page 19