Loading ...
Loading ...
Loading ...
10
STANDARD OR ANGLE MOUNTING INSTRUCTIONS
4. Depending on the length of downrod you use, you
may need to cut the lead wires back to simplify the
wiring. If you decide to cut back the lead wires, it is
suggested you do so in the following manner: Take the
lead wires and make sure you have pulled them all the
way through the top of the downrod. Measure 8 inches
of lead wire, then cut the excess wire o with wire
cutters (not included).
5. If you decided to cut back the lead wire in Step 4, strip
1/2 in. of insulation from the end of the white wire.
Twist the stripped ends of each strand of wire within
the insulation with pliers (not included). Repeat this
step for black and blue wires.
Important: If you did not cut back the lead wires in
Step 4, Step 5 is not necessary and you may proceed
to Step 6.
6. Install the ball end of the downrod (A) into the opening
of mounting bracket (D). Align one of the four slots
in the ball with the tab in the mounting bracket (D).
Note: The downrod (A) should not rotate if installed
correctly.
DANGER: Failure to align the slot in the downrod
(A) with the tab of the mounting bracket (D) could
cause the fan to fall, resulting in serious injury or
death.
Proceed to the Wiring on page 12.
4
8 in.
5
6
A
D
Tab
Slot
Slot
D
A
Loading ...
Loading ...
Loading ...