Loading ...
Loading ...
Loading ...
A CAUTION: Before performing any
service and adjustments:
1. Release control bar and stop engine.
2. Make sure the blade and all moving
parts have completely stooPed.
3. Disconnect spark plug wire from spark
plug and place where it cannot come
in contact with plug.
LAWN MOWER
TO ADJUST CuI"rlNG HEIGHT
See "TO ADJUST CU'I-rlNG HEIGHT" in
the Operation section ofthis manual.
REAR DEFLECTOR
The rear deflector,attached between the
rear wheels of your mower, is provided to
minimize the possibilitythat objects will
be thrown out of the rear ofthe mower into
the operator mowing position. If the
deflector becomes damaged, it should be
replaced.
DISCHARGE GUARD
The discharge guard, attached to the
discharge opening of your lawn mower, is
providedto prevent the possibility of injury
resulting from objects being thrown out of
the discharge opening into the operator
mowing position. If the discharge guard
becomes damaged, it should be replaced.
TO ADJUST HANDLE
The handle can be mounted in a high or
low position. The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle.
f. Remove upper handle and all parts
attached to lower handle.
2. Remove hairpincotters from lower
handle bracket mounting pin.
3. Squeeze lower handle in to remove it
from mounting pins.
4. Turn lower handle over to raise or
lower handle.
5. Squeeze lower handle in and position
holes onto mountingpins on handle
bracket.
6. Reassemble upper handle and all
parts removed from lower handle.
Lower "_
handle
Rotate _
ENGINE
ENGINE SPEED
Your engine speed has been factoryset.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that engine is running too fast or
too slow,take your mower to a Sears or
other qualified service center for repair
and adjustment.
CARBURETOR
Your carburetor has a non-adjustable
fixed mainjet formixture control. If your
engine does not operate propedydue to
suspected carburetor problems, take your
lawn mower to a Sears or other qualified
service center for repair and/or adjust-
ment.
IMPORTANT: Never tamgerwith the
engine governor, which is factory set for
the proper engine speed, Overspeeding
the engine above the factory high speed
scan be dangerous. If you think the
engine-governed high speed needs
adjusting, contacta Sears or other
qualified service center, which has proper
equipment and expedenoe to make any
necessary adjustments.
14
Loading ...
Loading ...
Loading ...