Loading ...
1. Troubleshooting Guide
No Spray
1) with unit off, fill both tanks with water, remove and replace each tank, turn on
and pull trigger
2) check pump belt for damage or wear
3) check flow indicator filter, tighten cap securely
4) hold tank over sink, manually activate valve on the bottom of each tank and
check for flow, check for gaskets on the exit port of each tank
5) check for debris in the receivers for each tank
6) attempt to spray through upholstery tool, if sprays, the problem is either a
pinebed hose, bad trigger valve, clogged heater or clogged spray tip (go to
#7): if no spray, the problem is either a bad pump, leaky Smart-Mix or leaky
tank receiver (go to #11)
7) actuate handle trigger slowly and feel for the actuation of the trigger valve (if
in doubt, remove upper handle assembly and actuate trigger valve manually)
8) unplug unit, remove main housing and cheek for pinched tubes
9) remove handle cover and cheek for pinched tubes
10) blow air through the heater and check for blockage
11) blow air through the trigger valve and check function
12) remove spray tips and cheek for blockage
13) replace pump and repeat #1
14) if still no spray, replace Smart-Mix assembly and/or tank receiver
Brush doesn't turn
1) check pump belt and brush belt for damage or wear
2) check to see if brush belt is on both pulleys
3) remove brush and check bearings and pivot arms, replace any damaged
components
4) check pump pulley for teeth damage, replace pump if damaged
No
suction/poor water recovery
1) check thatdiverter valve is in proper position/operates
2) check to make sure tank and lid are seated properly
3) check for drain plug and gasket
4) cheek both gaskets between tanks and unit, make sure the motor duet gasket does
not get sucked in when the unit is turned on, if so pull up gently on the gasket
5) check tank lid for damage
6) check that the float is not stuck in the up position
7) check placement of gasket between window and main housing
No suction from upholstery tool
1) check that diverter valve is in proper position/operates
2) check hose attachment at rear of unit
3) remove nozzle window, move diverter to upholstery/pre-treat, manually open
diverter door farther and check for proper position of upholstery duet
4) unplug unit, remove main housing
5) check duct/hose for clogs
03/03/99 Rev C
Loading ...
Loading ...
Loading ...