Loading ...
Loading ...
Loading ...
25
10-Troubleshooting
NZ AU
Problem Cause Solution
Excessive foam
detergent drawer.
Detergent is not a appropriate.
Excessive use of detergent.
Check detergent recommen-
dations.
Reduce amount of detergent.
Automatic adjust-
-
ment of washing
time.
Washing programme duration will
be adjusted.
This is normal and doesn‘t
affect functionality.
Spinning fails.
Check machine load and
laundry and run a spinning
programme again.
washing result.
Degree of pollution does not agree
with selected programme
Detergent quantitiy was not suffici-
Maximum load has been exceeded.
Laundry was unevenly distributed
in the drum.
Select an other programme.
Choose the detergent acc.
to
the degree of pollution
and
according to manufacture
specifications.
Reduce loading.
Loose the laundry.
W
ashing powder
r
esidues are on the
laundry.
Insoluble particles of detergent can
remain as white spots on the laun-
dry.
Perform extra rinse.
Try to brush the points from the
dry laundry.
Choose an other detergent.
Laundry has grey
patches.
Caused by fats such as oils, creams
or ointments.
Pretreat the laundry with a
special cleaner.
Note: Foam formation
If too much foam is inspected during spin cycle, motor stops and drain pump will be ac-
tivated for 90 seconds. If that elimination of foam fails up to 3 times, programme ends
without spinning.
applicance, disconnect the power supply and contact the customer service.
10.4 In case of poower failure
The current programme and its setting will be saved.
When power supply is restored operation will be
resumed.
If a power failure cuts an operating wash programme
door opening is mechanically bloc
10
ked. To get out any
laundry water level should not be seen in the glassy
parts.
10-1
When the washing machine in a safe state (under the water level below the window along a certain
distance, barrel temperature below 55 , the inner barrel did not turn), may unlock the doors of the
machine operation.
°C
Loading ...
Loading ...
Loading ...