Loading ...
Loading ...
Loading ...
16
Operation
OPERATING YOUR
AQUASTATION PURIFIER HOT
1. Ensure the upper pre-filtered water tank is
assembled inside the lower filtered water
tank, and that the water filter cartridge is
correctly fitted into position.
2. Plug into a 230/240V power outlet. The
purifier will beep, the water droplet light
will flash 3 times, the LCD screen will
illuminate, and AMBIENT will display on
the LCD screen to indicate the purifier is in
standby mode.
3. Use the pull ring at the back of the water
tank to assist in lifting it up and away from
the base of the purifier. Fill the pre-filtered
water tank with cold tap water to the MAX
level. Never fill past the MAX level. Once
water has filtered into the filtered water
tank, top up the tanks until the water level is
set to the MAX level.
4. Ensure the water tanks are assembled to the
purifier and place a cup of choice onto the
drip tray, or alternatively, remove the drip
tray to accommodate large glasses.
NOTE
Always ensure the water tanks are filled to the
MAX level for optimum flow of water from the
spout. Ensure the water tanks are filled above
MIN water level, or as soon as the FILL TANK
alert appears on the LCD display.
If the water level falls below the MIN tank
marking, the water sensor will automatically
stop dispensing and the Fill Tank indicator will
appear on the screen.
Regularly check and discard any water that
might accumulate in the drip tray.
TURNING OFF THE PURIFIER
Turn off at the power outlet.
IMPORTANT
Turning the purifier off at the power outlet will
delete the 'last setting' memory function.
NOTE
Discard any filtered water that has been left
sitting for several days or more. This will
ensure you have cleaner, great-tasting water.
If your filter has been unused for a long period
of time, it is recommended to resoak the filter
for 10 minutes before use and clean the water
tanks as per the cleaning instructions found in
this book.
STANDBY MODE
When the unit is plugged into the power outlet,
the water droplet light will flash 3 times, the
display screen will illuminate and AMBIENT
will appear on the display screen to indicate
the purifier is ready for use.
The purifier will automatically go into energy-
saving standby mode after 5 minutes if not
used. The water droplet light will turn off when
in standby mode.
To awaken the purifier, press any button or
press/turn the FUNCTION dial once; one long
beep will sound, the water droplet light will
illuminate white and flash rapidly 3 times to
indicate that the purifier is ready to use.
Loading ...
Loading ...
Loading ...