Kenmore 79075728992 gas range

User Manual - Page 17

For 79075728992.

PDF File Manual, 21 pages, Download pdf file

Loading ...
Loading ...
Loading ...
General Cleaning
(continued)
The door isheavy. For
safe, temporary storage, laythe door
flat with the inside of the door facing
down.
[]
_,,hdm_v_ r_pr
Figure 1
Figure 2
To Remove and Replace Oven Door
TO Remove Oven Door:
1. Open the door.
2. Remove screws located on the inside of the oven door near the hinges
A (one on each side.)
3. Close the door to the quarter-open position. Grasp the door firmly on
both sides and lift up and off the hinges.
4. To clean oven door, follow the instructions provided in the cleaning
chart under General Cleaning
Lift do_ straight off 2 docw hinges
To Replace Oven Door:
1. Be sure the hinge arms are in the quarter-open position. Be careful if
pulling the hinges open by hand. The hinges may snap back against the
oven frame and could pinch fingers.
2. Hold the door at the sides near the top. Insert the hinge arms into slots
at the bottom of the door.
3. Hinge arms must go into the range slots evenly. The hinge arms should
be inserted into the bottom corners of the door as far as they can go.
4. If the door is not in line with the oven frame, remove it and repeat the
above steps.
To Remove and Replace Warm & Ready Drawer (if equipped)
To Remove Warmer Drawer:
1. _ Turn power off before removing the Warm & Ready
drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left glide lever
and push down on the right glide lever (see figure 1).
5. Pull the drawer away from the range.
To Replace Warm & Ready Drawer:
1. Pull the bearing glides to the front of the chassis glide (see figure 2).
2. Align the glide on each side of the drawer with the glide slots on the
range.
3. Push the drawer into the range until levers "click" (approximately 2").
Pull the drawer open again to seat bearing glides into position. If you
do not hear the levers "click" or the bearing glides do not feel
seated remove the drawer and repeat steps 1 thru 3. This will
minimize possible damage to the bearing glides.
"_ _ Electrical Shock Hazard can occurand result
in serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
17
n3
r--
-r-
Loading ...
Loading ...
Loading ...