Loading ...
Loading ...
Loading ...
7
English
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can causeinjury.
WARNING: Risk of unsafe operation. Unit
cycles automatically when power is on.
When performing maintenance, you may be
exposed to voltage sources, compressed air,
or moving parts. Personal injuries can occur.
Before performing any maintenance or repair,
disconnect power source from the compressor
and bleed off all airpressure.
Customer Responsibilities
Before each
use
Daily or after
each use
See tank
warning
label
Check Safety Valve
X
Drain Tank X
Remove tank from
service
X
1
1- For more information,
call our Customer Care Center at 1–888–331–4569
nOTE: See Operation section for the location ofcontrols.
To Check Safety Valve (Fig. C)
WARNING: Risk of Bursting. If the safety valve
does not work properly, over-pressurization may
occur, causing air tank rupture or an explosion.
WARNING: Risk from Flying Objects. Always
wear certified safety equipment: ANSI Z87.1 eye
protection (CAN/CSA Z94.3) with sideshields.
Before starting compressor, pull the ring on the safety
valve
8
to make sure that the safety valve operates freely. If
the valve is stuck or does not operate smoothly, it must be
replaced with the same type ofvalve.
How to Start
1. Set the On/Off switch
4
to “On” and allow tank pressure
to build. Motor will stop when tank pressure reaches
“cut-out”pressure.
2. Turn regulator knob
7
clockwise to increase pressure
and stop when desired pressure isreached.
WARNING: Risk of unsafe operation. If any
unusual noise or vibration is noticed, stop the
compressor immediately and have it checked by
a trained servicetechnician.
The compressor is ready foruse.
Fig. C
8
To Drain Tank (Fig. A, D)
WARNING: Risk of Unsafe Operation. Air tanks
contain high pressure air. Keep face and other
body parts away from outlet of drain. Use
ANSIZ87.1 eye protection (CAN/CSA Z94.3) when
draining as debris can be kicked up into face.
WARNING: Risk from noise. Always wear proper
hearing protection during use. Under some
conditions and duration of use, noise from this
product may contribute to hearingloss.
nOTE: All compressed air systems generate condensate
that accumulates in any drain point (e.g., tanks, filter,
aftercoolers, dryers). This condensate contains lubricating
oil and/or substances which may be regulated and must be
disposed of in accordance with local, state, and federal laws
andregulations.
WARNING: Risk of Bursting. Water will condense
in the air tank. If not drained, water will corrode
and weaken the air tank causing a risk of air
tankrupture.
NOTICE: Risk of Property Damage. Drain water
from air tank may contain oil and rust which can
causestains.
1. Set the On/Off switch
4
to “Off”.
2. Turn the regulator knob
7
counterclockwise to set the
outlet pressure tozero.
3. Remove the air tool oraccessory.
4. Place a suitable container under the drain valve to
catchdischarge.
5. Pull ring on safety valve
8
allowing air to bleed from
the tank until tank pressure is approximately 20psi.
Release safety valvering.
6. Drain water from air tank by opening drain valve
10
on
bottom oftank.
Loading ...
Loading ...
Loading ...