Loading ...
Loading ...
Loading ...
9
Install Range Hood
1.
Remove the grease filters. See the “Range Hood Care” section.
2. Remove foam shipping pad from behind the blower motor.
3. Lift the range hood up under cabinet and determine final
location by centering beneath cabinet. Mark on the underside
of cabinet the location of the 4 keyhole mounting slots on the
range hood. Set range hood aside on a covered surface.
4. Use ¹⁄₈" (3 mm) drill bit and drill 4 pilot holes as shown.
5. Install the 4 - 4.5 x 13 mm mounting screws in pilot holes.
Leave about ¹⁄₄" (6.4 mm) space between screw heads
and cabinet to slide range hood into place.
Vent Connector Installation
Determine whether the range hood will be installed using either
a top or rear vent connection.
Top Vent Connector Installation
1. Remove the top vent knockout.
2. Attach the round vent transition damper using 2 vent
transition mounting screws.
3. Remove tape from damper flap
NOTE: If the wall cap is directly behind the vent connector,
the dampers in the connector and wall cap must not interfere.
Remove the vent connector damper if they interfere.
Rear Vent Connector Installation
NOTE: For rear venting, the blower motor position must be
changed. It will need the rear motor mounting bracket that
is included with the 3¹⁄₄" x 10" (8.3 cm x 25.4 cm) Damper
Assembly/Motor Mounting Bracket Kit that must be purchased
separately. See “Assistance or Service” section to order.
1. Remove the rear vent knockout.
2. Place range hood on its back.
3. Using a T10 Torx
®
adapter, remove the 8 screws holding
the bottom panel assembly in place. Remove the bottom
panel assembly and set it aside.
4. Disconnect the blower motor electrical connector from
the electrical box connector.
5. Using a T10 Torx
®
adapter, remove the 4 screws from the
motor cover plate. Remove the motor cover plate and set
it aside.
A. Keyhole slot
A. Drill pilot hole
A. Top round vent transition
B. Top round vent transition
mounting screws (2)
C. Top vent knockout
D. Rear vent knockout
E. Rear rectangular transition
knockout mounting screws (3)
F. Hi ng e p in
G. Rear rectangular vent transition
A
A
¹⁄₄"
(6.4 mm)
A
B
C
D
F
G
E
A. Blower motor cover plate
B. Blower motor cover plate
mounting screws (4)
C. Back of range hood
D. Bottom panels assembly
E. Bottom panels assembly
mounting screws
B
A
C
D
E
E
E
E
Loading ...
Loading ...
Loading ...