Loading ...
Loading ...
Loading ...
STIEBEL ELTRON
7
Operation Instruction for the user and the qualied installer
Guarantee
Steel, copper, or plastic piping
systems. If plastic piping systems
are being used, the following
instructions are to be respected.
- Temperature : max 50 ˚C
- Pressure : max 1000 kPa
The unit must be connected to
the protective earth conductor
(see electric circuit diagram).
6. Installation location
The instantaneous water heater
should be installed in an enclosed
frost-free area, if possible close to the
drawing-o point (when dismantled, the
unit is to be stored in a place not subject to
frost, because there will always be some
residual water left inside). The unit is to be
installed vertically, as in Example (Fig. 1)
7. Care and maintenance
All the information in these
instructions for operation and
installation must be followed carefully.
They provide important information
regarding safety, operation, and
maintenance of the unit.
A damp cloth is sucient to clean the
outside of the unit. Do not use any foam-
ing or abrasive cleaning agents!
Maintenance work may only be
carried out by a qualied installer.
When carrying out any work,
disconnect the unit from the
mains.
8. Guarantee
For guarantees please refer to the respec-
tive terms and conditions of supply for
your country.
The installation, electrical
connection and rst operation
of this appliance should be carried
out by a qualied installer.
The company does not accept
liability for any failure caused
by inproper installation and / or
unauthorized installers.
Loading ...
Loading ...
Loading ...