Everdure SNNGC-13 Sunbury eSee Natural Gas BBQ

User Manual - Page 8

For SNNGC-13.

PDF File Manual, 24 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
STYLE, GRILLED TO PERFECTION
LIGHTING PROCEDURE
Read all operating instructions before lighting.
Open roasting hood before lighting.
Make sure all gas control knobs are in the ‘Off’ position and open cylinder
valve or connect natural gas.
LIGHTING THE BARBECUE USING THE ELECTRONIC IGNITION
The Everdure 4 burner barbecue has 1 battery operated igniter to operate the appliance. The sparker ignites
the second burner in from the right hand side. The remaining burners are ignited by a cross over channel.
Before attempting to light the barbecue, please ensure that a battery has been placed in the battery operated
igniter. To check for, and replace a battery, the black and silver cap requires removing. The cap is removed
by turning in an anti – clockwise direction. A battery can then be placed into the box and the cap replaced.
The barbecue can then be lit by the following procedure:
1. Press in the control knob to the left hand side of the ignition button and turn to high.
2. Hold the control knob in and press the ignition button until the burner ignites.
3. Release the ignition button & continue to hold the control knob in for 10 seconds to activate the flame
safeguard. If the burner fails to ignite within 5 seconds of pressing the ignition button, turn the control
knob to off and allow the unburned gas to dissipate before attempting ignition again (5 minutes). If
ignition continues to fail refer to the “Trouble Shooting” section.
4. To achieve ignition on the remaining burners turn either of the adjacent control knobs to ‘High’, and hold
in for 10 seconds. The burner will ignite from the first burner.
MANUAL IGNITION
To light the barbecue manually, the fat tray is removed. Any burner can then be lit by a match from below.
Once lit, the fat tray is replaced in position.
LIGHTING SYSTEM INSTRUCTIONS
Check that the barbecue wiring is connected to the power pack (screwed onto the top of the power pack).
Check that the lighting switch is off, and plug the power pack into the power supply. With the power supply
on, the lighting switch at the front right hand corner of the barbecue can be used to turn the lights on and
off. When not in use, the unit should be disconnected from the power supply and all cords stored within the
trolley.
Black & Silver cap
Battery
Ignition box
Fascia Panel
Side View
Turn knob
anti-clockwise
to “Hi”
8
Loading ...
Loading ...
Loading ...