Loading ...
Loading ...
Loading ...
22
WORKTOPS/UNDERCOUNTERS & SANDWICH UNITS
OPERATIONS MANUAL
FIGURE 17: Front Breather Duct Kit (3” high)
(2) THUMBSCREWS
FRONT GRILL
LEFT HAND
AIR DUCT/ SKIRT
RIGHT HAND
AIR DUCT/ SKIRT
(4) 3" CASTERS
NOTE: INSTALL
AIR DUCT/SKIRTS
WITH CUT-OUTS
TOWARD BACK
OF CABINET
FIGURE 17A: Front Breather Divider Kit (2’ high)
INSTALLING FRONT BREATHER KIT (Skirt and Grill)
IMPORTANT NOTE: You may CAREFULLY lay the cabinet
on it’s back, but only FOR A BRIEF PERIOD OF TIME.
Caution must be taken to ensure you DO NOT DAMAGE
the louvered back panel, refrigeration system compo-
nents, or copper tubing located behind the panel. The
cabinet must be properly blocked, to allow room to get
your hands in to lift without damaging the cabinet or
crushing the vents on the back panel. DO NOT PLUG-IN
OR OPERATE THE REFRIGERATION SYSTEM FOR AT
LEAST THREE (3) HOURS AFTER THE UNIT HAS BEEN
RETURNING IT TO AN UPRIGHT POSITION, AS THIS
CAN DAMAGE THE COMPRESSOR.
FRONT BREATHER DUCT KIT (3” high)
Position the left hand air duct/skirt (see Figure 17) as shown.
Attach the front left caster by inserting threaded end through the
slot in the air duct/skirt and screwing it into the threaded hole in
the bottom of the cabinet. Do not tighten completely. Repeat for
the back left caster. Follow these steps for the right hand air/duct
skirt and remaining casters. Position the front grill as shown
and attach it to the front edge of the air duct/skirts using the
thumbscrews provided. Adjust the position of the air duct/skirts
and the front grill as needed. Tighten the thumbscrews and all 4
casters completely. Carefully lift the cabinet upright and check
that the grill and casters are secure.
FRONT BREATHER DIVIDER KIT (2” high)
Position the air divider (see Figure 17A) as shown. Attach with
lag bolts and secure secure plate casters as shown.
Your refrigerator or freezer is now front breathing and can be
completely enclosed on the sides, back and top. The refrigera-
tion system will take in fresh air through one side of the front
grill, pull it under the cabinet, through compressor compartment
to cool the condenser, back out under the cabinet and exhaust it
through the other side of the front grill.
ANY RESTRICTIONS TO THE AIR FLOW THROUGH THE
FRONT GRILL OR UNDER THE CABINET CAN DAMAGE
THE REFRIGERATION SYSTEM AND WILL VOID ALL
WARRANTIES.
MOUNTING CASTER SUPPORT PLATES
If the standard stem casters on a cabinet are not properly main-
tained and tightened, or if the unit is excessively overloaded and
moved around, the threaded inserts in the bottom of the cabinet
can become stripped, twisted or collapsed. If this occurs and
the stem casters cannot be mounted securely, rigid caster sup-
port plates can be fitted to provide the strength needed to safely
use your cabinet. Each caster support plate assembly is made
of heavy gauge galvanized steel, with (2) casters permanently
welded to it, for maximum rigidity. The plate has a series of
holes that will allow you to fasten the plate assembly to the bot-
tom of the cabinet with sheet metal screws and bolts. Contact
the factory to obtain the correct parts for your model.
Loading ...
Loading ...
Loading ...