Loading ...
Loading ...
Loading ...
13
Your ring grates, top grates and burner heads may darken over time with use. This is normal.
TIP: To prevent your burners from darkening at an uneven rate, rotate the ring grate and top grates between more and
less active burners.
BURNER CLEANING
Ring Grates and Top Grates
TIP: Clean spills as soon as possible to prevent sticking and build up.
When burner is cool, remove the ring grate, top grate and center filler grate (30” models only).
Wash in hot, soapy water. Rinse well and dry thoroughly to prevent rusting.
Handle gently to prevent nicks/chips, which can lead to rusting
TIP: If you have a nick or chip you can season the area to prevent rusting. Nicks or chips are not covered under warranty.
Put corn oil or other high smoke point oil on a paper towel and rub onto rusted area.
Wipe away excess oil and replace the part on the range.
Do not submerge the burner grates in water for extended periods of time. Prolonged exposure to moisture
may cause rusting.
For heavy soiling, use a commercially available oven cleaner. Follow the cleaner manufacturer’s
instructions.
Make sure the cleaning chemicals do not contact any stainless steel or painted surface on your
appliance.
Reinstall grates in cooktop and make sure they are seated properly, and do not move unsteadily from side
to side.
Burner Caps (Sealed Burner Models Only)
Burner caps locations are specific to the valves on the front of the unit. If burner caps are removed for
cleaning or other purposes, they must be re-installed in the same location they were removed from.
Failure to do so may result in a burner that will not light or possibly have a high flame.
TIP: Clean spills as soon as possible to prevent sticking and build-up, and to keep the burner ports clear.
For fresh spills, make sure burner is cool and clean with a cloth and hot water.
Burner Heads (Open Burner Models Only)
Burner head locations are specific to the valves on the front of the unit. If burner heads are removed for
cleaning or other purposes, they must be re-installed in the same location they were removed from.
Failure to do so may result in a burner that will not light or possibly have a high flame.
TIP: Clean spills as soon as possible to prevent sticking and build-up, and to keep the burner ports clear.
For fresh spills, make sure burner is cool and clean with a cloth and hot water.
If needed, the burner head can be removed for cleaning:
When cool, remove the ring grate and top grate.
CAUTION
ATTENTION
ATTENTION
ATTENTION
ATTENTION
Loading ...
Loading ...
Loading ...