Loading ...
Loading ...
Loading ...
BEFORE STARTING THE CLEANING
SYSTEM
To operatetheengineyouwillneedtodothefollowing:
Add Engine Oil
only use high qualitydetergentoil ratedwith API
service classificationSF or SG. Selectthe oil'sSAE
viscositygrade accordingto yourexpected operating
temperature:
colder _ 32°F _ warmer
,,t II J,
5W30 SAE 30
Althoughmulti-viscosityoils(5W30, 10W30, etc.)
improve startingin coldweather, these multi-viscosity
oilswill resultin increasedoilconsumption when used
above 32°F. Check yourengine oil level more
frequentlyto avoidpossibledamage from runninglow
on oil.
Place cleaningsystemon a level surface
Clean area aroundoilfillcap and remove.
Dil Fill Cap
/
Oil Drain Plug
Pour oilfrom enclosedbottle intothe oilfillopening
untiloil reachesthe point of overflowing. Do not
overfill.
Install oilfillcap. Hand tightensecurely.
Add Gasoline
• Use regular unleaded gasolinewith thecleaning
system engine. Fueltank capacityis 1 gallon.
,_ DANGER: Never fillfuel tank indoors.Never fill
fueltankwhen engineis runningor hot.Do not
smokewhen fillingfuel tank.
,_ CAUTION: Do notoverfillthefuel tank. Always
leave roomfor expansion.
,&
CAUTION: Experienceindicatesthatalcohol
blendedfuels (calledgasoholor usingethanol
or methanol) can attract moisturewhichleadsto
separationandformationof acidsduring
storage.Acidicgas can damage thefuel system
ofan enginewhilein storage.
To add fuel toengine:
Clean area aroundfuel cap, removecap.
• Add regular unleaded gasoline,slowly,to the fuel
tank.
Important: Never mix oilwith gasoline.
• Install fuel cap and wipe up any spilledgasoline.
TO START THE CLEANING SYSTEM
The best way to startyourcleaningsystem engine for
the firsttime isto followthese instructionsstep-by-
step. This startinginformationalso applies whenever
you startthe engine afteryou have letthe cleaning
system sitidle for at least a day.
Place the cleaningsystem in an area close enough
to an outsidewater soume that canflow at a rate of
at least 3 gallonsper minute. Connect a garden
hose to the water spout.
• Check that the high pressurehose is tigh'tly
connectedto the spray gunand to the pump. See
ASSEMBLY sectionon page 4.
• Check inletscreen on the water inlet. If the screen
is dirty,clean beforeattachinga garden hose. ffthe
screen is damaged, do not connectto the garden
hose. Replacewith screen providedin maintenance
kitor cell 1-800-366-PART toorder a replacement
inlet screen.
• Attach thethe garden hose tothe water inlet.
• Tum on the water,
,& CAUTION_Do not runpumpwithoutthe water
supplyconnected and turned on. You must
follow this cautionor the pumpwillbe damaged.
• Remove the dual lance from the spray gun.
• Pullthe tdggeron the spray gunand hold untila
steady stream ofwater appears.
• Engage the safety latchon the spraygun.
• Attach dual lance ontospray gun.
Loading ...
Loading ...
Loading ...