Loading ...
Loading ...
Loading ...
Installation Instructions
INSTALLING THE WASHER
1. Run some water fl'om the hot and cold fimcets to flush
the water lines and remove particles that might clog up
the water valve screens.
2. Remove the inlet hoses and rubber washers fl'om the
plastic bag and install the rubber washe_ in each end
of the inlet hoses.
3. (90 ° elbow end)
Carefifllv com_ect the inlet
hose marked HOT to the
outside "H" outlet of the
water \;five. Tighten by
hand, then tighten another
2/3 mrn with pliers.
Carefifllv com_ect the other
inlet hose to the inside "C"
outlet of the water wflve. Tighten by hand; then tighten
another 2/3 mrn with pliers. Do not crossthread or
over-tighten these comaections.
4. Com_ect the inlet hose ends to the HOT and COI,D
water fimcets tightly by hand, then tighten another 2/3
mrn with pliers. Turn the water on and check fin" leaks.
5,
6,
Careflfllv move the washer to its final location. Genflv
lifi up on the fl'ont of the washer and slide back.
NOTE: Do not use the dispenser drawer or door to lifi
the washer.
_]th the washer in its
final position, place a
level on top of the
washer (if the washer
is installed trader a
counter, the washer
should not be able to
rock). At!just the fl'ont
leveling legs up or
down to ensure the washer is resting solid. Tm'n the
lock nuts on each leg up towards the base of the
washer and snug with a wrench.
NOTE: Keep the leg extension at a minimum to
prevent excessive vibration. The fi_rther out the
legs are extended, the more the washer will vibrate.
If the floor is not level or is damaged, you may have
to extend the rear leveling legs. For tmdercounter
instnllations, you can at!just the rear legs by removing
the front service panel.
15
Loading ...
Loading ...
Loading ...