Loading ...
Loading ...
Loading ...
Installation Instructions
ELECTRICAL REQUIREMENTS
Read these instructions completely
and carefully.
CIRCUIT - Individual, properly polarized and grounded
15-amp branch circuit fllsed with 15-amp time-delay fllse
or circuit breaker:
POWER SUPPLY- 2-wire, with grotmd, 120wolt, single-
phase, 60-Hz, Mternating CmTent.
OUTLET RECEPTACLE - Properly grotmded
3-prong receptacle to be locamd so the power supply coM
is accessible when the washer is in an installed position.
@
@
GROUNDING REQUIREMENTS
WARNING: ImI,,oI,e,connectionofthe
equipment grotmding conductor can result in a risk
(ff electrical shock. Check with a licensed electrician
if you are in doubt as to whether the appliance is
propedy grotmded.
1. The washer MUST be grotmded. In the event ot
malflmcfion or breakdown, grounding will reduce
the risk ot electrical shock by providing a path of least
resistance t0r electrical cmTent.
Since v(>m"washer is equipped with a power sui_plv
cord having an equipment-gromMing conductor and
a grotmding plug, the plug MUST be plugged into an
ai)i)ropriate , coppe_vired receptacle that is i)roperly
installed and grotmded in accordance with all local
codes and ordinances or in the absence ot local codes,
with the National Electrical Codes, ANSI/NFPA 70
(latest edition)./t in doubt, call a licensed electfidan.
DO NOT ('lit off-or alter the grotmding prong on the
power supply cord. In situations where a two-slot
receptacle is present, it is the owner's responsibility to
have a licensed electrician replace it with a properly
grounded three-prong gromMing-Qpe receptacle.
WATER SUPPLY REQUIREMENTS
Hot and cold water fimcets MUST be installed within
42 inches (] 07 cm) of yore" washer's water inlet. The
fimcets MUST be 3/4" (1.9 cm) garden hose-t)'l)e so
inlet hoses can be connected. Water pressm'e MUST be
bet_ven 10 and 120 pounds per square inch (maMmum
tmbalanced pressm'e, hot vs. cold, l 0 psi.) Y_)m"water
department can a(Mse you of yore" water pressm'e.
The hot water temperature should be set to deliver
water at 120 ° to 140°F (48°-60°C).
DRAIN REQUIREMENTS
1. Drain capable ot eliminating 17 gals (64.3 i,)
per minute.
2. A standpipe diameter of 1 1/4" (3.18 cm) minim urn.
3. The standpipe height above the floor
should be:
Minimum height: 24" (61 cm)
Maxim um height: 96" (244 cm )
O
o oo
BACK
96 in.
(244 cm)
Max.
24 in.
(61 cm)
Min.
NOTE: The drain hose attached to the washer can reach
a 58" (147 cm) high standpipe. For a higher standpipe,
contact an authorized parts distributor: If the drain is less
than 24" (61 cm), install a siphon break kit, available at
yore" local hardware store.
14
Loading ...
Loading ...
Loading ...