Loading ...
Loading ...
Loading ...
RABBETING
Rabbeting is known as cutting out a section of the corner
of a piece of material.
To make a RABBET requires two cuts which do not go all
the way through the material. Therefore the blade guard
must be removed.
1. Remove blade guard.
2. Adjust rip fence and blade to required dimensions.
3. Make first cut through edge. Follow resawing
procedure.
4. Remove auxiliary fence and make second cut.
5. INSTALL BLADE GUARD IMMEDIATELY UPON
COMPLETION OF RABBETING OPERATION.
Rabbet cuts can also be made using the dado head or
molding head.
DADOING
Instructions for operating the Dado Head are contained in
booklet furnished with the Dado Head.
The recommended Dado Head is listed, under
recommended Accessories.
The arbor on the saw, is only long enough so that the
widest cut that can be made is 13/16" wide.
When installing the dado head on the arbor, ALWAYS;
install the inside "loose collar" first.
It is not necessary to install the outside loose collar before
screwing on the arbor nut. Make sure the arbor nut is tight.
ALWAYS USE DADO INSERT listed under recommended
Accessories,
When using the dadoing head it will be necessary to remove
the Blade Guard and Spreader. USE CAUTION.
ALWAYS REPLACE THE BLADE GUARD AND
SPREADER WHEN YOU ARE FINISHED DADOING.
MOLDING CUTTING
Instructions for operating the Molding Head are contained
in a booklet furnished with the Molding Head.
The recommended molding head is listed under
recommended Accessories.
Always use Molding Insert listed under recommended
Accessories.
LOOSE
DADO INSERT
/
HEAD
ARBOR NUT
When using the molding head it will be necessary to remove
the Blade Guard and Spreader. USE CAUTION.
ALWAYS REPLACE THE BLADE GUARD AND
SPREADER WHEN YOU ARE FINISHED MOLDING:
ADJUSTMENTS
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF" AND REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE MAKING ANY ADJUSTMENTS.
MITER GAUGE
NOTE: The graduations on the miter gauge provide
accuracy for average woodworking. In some cases where
extreme accuracy is required, when making angle cuts, for
example, make a trial cut and then recheck it with an
accurate square or protractor.
If necessary, the miter gauge head can be swiveled slightly
1:ocompensate for any inaccuracy.
The HEAD should be SQUARE (90° ) with the bar when
the pointer points to "0",
To check for squareness, place an accurate square on the
miter gauge. If the head is NOT SQUARE with the bar:
1. Loosen the lock knob.
KNOB
BAR
2. Position the head square with the bar . . . tighten the
lock knob.
3. Loosen the screw and adjust the pointer, so it points to
zero.
The swiveling movement of the head can be adjusted by
tightening or loosening the set screw located in side of the
head using the t/8 in. setscrewwrench.
2S
Loading ...
Loading ...
Loading ...