Loading ...
Loading ...
Loading ...
16
MAINTENANCE
WARNING
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance.
Service
WARNING
Preventive maintenance performed by unauthorized personnel may
result in misplacing of internal wires and components which could
cause serious hazard.
We recommend that all tool service be performed by a Skil Factory
Service Center or Authorized Skil Service Station.
General Maintenance
WARNING
When servicing, use only identical replacement parts. Use of any other
parts could create a hazard or cause product damage.
NOTE:
Periodically inspect the entire product for damaged, missing, or loose parts such as
screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this
product until all missing or damaged parts are replaced. Please contact customer service or
an authorized service center for assistance.
Cleaning
WARNING
The tool may be cleaned most effectively with compressed dry air.
Always
wear safety goggles when cleaning tools with compressed air.
Ventilation openings and switch levers must be kept clean and free of foreign matter. Do not
attempt to clean by inserting pointed objects through openings.
WARNING
Certain cleaning agents and solvents damage plastic parts.
Some of
these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents,
ammonia and house hold detergents that contain ammonia.
Storage
Store the tool indoors in a place that is inaccessible to children. Keep away from corrosive
agents.
TROUBLE SHOOTING
Problem Cause Remedy
Tool will not start. 1. Battery pack is depleted. 1. Charge the battery.
2. Tool is over-loaded. 2. Release the variable-speed trigger
switch and try again.
3. Battery pack is over
temperature.
3. Turn off the impact wrench and cool
the battery pack under air ow.
4. Battery pack is not installed
properly.
4. Conrm that the battery is locked
and secured to the tool.
5. Burned out switch. 5. Have the switch replaced by an
Authorized SKIL Service Center or
Service Station.
LED light rapidly
ashes.
1. Tool is over-loaded. 1. Release the trigger switch.
2. Tool is over-temperature. 2. Cool the tool under air ow.
Loading ...
Loading ...
Loading ...