Loading ...
Loading ...
Loading ...
BEFORE CALLING FOR SERVICE (continued)
Water in the washer drains Drain hose is kinked, pinched, or
slowly or not at all, or the clogged.
display shows:
Drain discharge is more than 96 inches
above bottom of washer.
The display shows:
The display shows:
__
The display shows:
I L-E!
The display shows:
The washer has detected an out of
balance load.
if the ub rebalance (see above) is not
successful, this error will be displayed.
The load istoo small.
Heavy articles are mixed with lighter
items.
The load is out of balance.
Control error.
Water level is too high due to a faulty
water valve.
Make sure the drain hose is free of
clogs, kinks, etc., and isnot pinched behind
or under the washer.
Adjust or repair drain. Maximum drain
height is 96 inches (8 ft.)
If the washer detects a load that is too
far out of balance to spin, it will dis-
play this code while it is attempting to
rebalance the load. The washer will
add water and try to redistribute the
load automatically. This display is for
your intormation only, and no action is
required.
automatic attempt to rebala_ the load
was not _ssfuL The cycle has been paused
to allow the load to be marCJallyadjusted.
Small loads may need additional itemsto be
added to ailow the washer to balance the
loads.
Tke load may have heavy itemsloaded with
lighter items.Always try to wash articles of
somewhatsimilar weight to allow the washer
toevenly distribute _ weight of the load for
sp_nnJng.
Manually redistribute the load if articles have
become tangled preventing the automatic
distribution f_ornworking properly.
Unplug the washer and wait 60 seconds.
Reconnectpower and try again, ff the error
reappears, call for serw'ce.
Close the water faucets, unplug the wash-
er, and call for service.
The display shows: The water level sensor is not working Close the water faucets, unplug the wash-
correctly, er, and call for service.
The display shows: A motor error has occurred. Allow the washer to stand for 30 minutes
and then restart the cycle. If the LEerror
code persists, call for service.
The display shows: Clutcherror. Mechanical failure.
Unplug the washer and call for service.
The display shows: Foreign objects, such as coins, pins, dips, Turn off the washer and then press the
etc., caught between the wash plate Power button. Pressthe spin speed button
_| and the inner basket, without selecting a cycle to drain and
spin the load.
When the spin is complete, remove the
clothes and then find and remove any
objects caught in the wash plate.
Always check pockets, etc., before wash-
ing to prevent error codes or damage to
the washer or c!othing.
32
Loading ...
Loading ...
Loading ...