Loading ...
Loading ...
Loading ...
Note:Rememberthetwo-speedfeature(HI-LO)when
settingtorqueTheamountoftorquewillvarydepending
onwhichspeedsettingyouhaveyourdrilt-driver.Switch-
ingtoLOspeedwill increase torque Switching to Ht
speed will decrease torque
BIT STORAGE
See Figure 11o
When not in use, bits provided with your drill can be
ptaced in the storage area located on the top of your drill
as shown in figure 11o
SCREWDRIVERBIT(S) BIT STORAGEAREA
_t 1 Fig 11
_ WARNING: Always wear safety goggles or safety
glasses with side shields when operating tools.
Failure to do so could resutt in objects being thrown
into your eyes, resulting in possible serious injury.
LEVEL DRILLING
See Figure 12.
A convenient new feature provided with your drill is a
leve! It is recessed in the motor housing on top and end
of your drill. It can be used to keep drill bits level during
drilling operations_
®
LEVEL
TOPVIEW
Fig. 12
DRILLING
See Figure 13
LEVEL
ENDVIEW
12
Fig 13
When drilling hard smooth surfaces use a center punch to
mark desired hole location This will prevent the drill bit
from slipping off center as the hole is started However,
the low speed feature allows starting holes without center
punching if desired To accomplish this, simply operate
your drill at a tow speed until the hole is started
The material to be drilled should be secured in a vise or
with clamps to keep it from turning as the drill bit rotates.
Hold tool firmly and place the bit at the point to be drilled.
Depress the switch trigger to start tool.
Move the drill bit into the workpiece applying only enough
pressure to keep the bit cutting. Do not force or apply side
pressure to elongate a hole.
_ WARNING: Be prepared for binding or bit
breakthrough. When these situations occur, drill has
a tendency to grab and kick opposite to the direction
of rotation and could cause loss of control when
breaking through material.. If not prepared, this loss
of control can result in possible serious injury
When drilling metals, use a light oil on the drill bit to keep
it from overheating. The oil wilt prolong the life of the bit
and increase the drilling action°
If the bit jams in workpiece or if the drill stalls, release
switch trigger immediately Remove the bit from the
workpiece and determine the reason for jamming.
Loading ...
Loading ...
Loading ...